Sirius Corp Logger [built in GPS] GS902 - ECEFastGPS.pdfAutomatic Alarm Report: Not only alarm is...
Transcript of Sirius Corp Logger [built in GPS] GS902 - ECEFastGPS.pdfAutomatic Alarm Report: Not only alarm is...
Sirius Corp
GPS Data & Measurement Logging
2 x Analog Channels + 1 x Pulse Channel + 4 x Digital Channels + 2 x Relay Outputs
Upload Data & GPS information via GPRS and SMS on schedule or alarm triggered
Programmable data logging and upload interval
Temperature Sensor channel [GS902S]
Alert user when temperature is high/low
GPRS Data Logger [built in GPS] GS902
Overview
♦ Both I/O Data & GPS data tracking via GPRS / SMS
♦ Data logging in internal memory
♦ GPRS Real Time Data & Historical Data Upload
♦ Real Time Alert on GPS Features
♦ Real Time Alert on triggered alarm input and analog levels
♦ Panic Button triggered GPS data report via GPRS & SMS
♦ Integrated 16 bit MCU & Quad‐band GSM/GPRS Module
Data Logger Features
∗ 2 High Precision A/D Channels
∗ 4 DI [Digital Input] or 1 DP [Digital Pulse] Channels
∗ 2 DO [Digital Output] Channels
∗ Optional 1 Temperature Sensor [‐50 ~ 125°C], programmable high/low alert temperature level
∗ Programmable data capturing type, range, start point, alert high/low and pulse level
∗ Device configuration setup by PC software via USB port
∗ Device parameters checked via SMS or PC software
∗ Programmable Data Upload Interval (5 seconds ~ 24 hours)
∗ Programmable Data Logging Interval (1 min ~ 60 min)
∗ Remote Configuration by SMS or GPRS
∗ USB Port for PC communication
∗ Support Dynamic Domain Name or Fixed IP
∗ Support TCP protocol data transmission
∗ 1MB Non‐volatile Memory maintaining max. 30 days period of data
Channel Specification
Pulse Input: Accumulated 99999999 pulses
5~15VDC input
Pulse Frequency Measure > 20ms
Max. 50 pulses per second
Digital Output: max. DC24V @3A, AC120V @3A
GPRS Data Logger [built in GPS] ~ Data Logging Function
Analog Input: 4 ~ 20mA
Input Impedance: 250Ω [current type input]
Accuracy: 12bit AD Converter
2.5/ 4096=0.00061 (0.061%)
Digital On/Off Input : Optic coupler dry contact
Triggered Level > 20ms
Alarm Detection 1. Over speed alert
Automatically send alerts when driving speed exceeds user defined speed
2. Position Lock
Automatically send alerts when the vehicle is moved apart from its parking position
3. Fencing In (min. 0.18m), multiple points
Alert (SMS/Dial/GPRS) when moving into security zone
4. Fencing Out (min. 0.18m), multiple points
Alert (SMS/Dial/GPRS) when moving out of security zone
5. Panic Button
Emergency report with position information for both personal and vehicle alarm
6. Idle time monitoring
An early warning security feature when vehicle is idle longer than predefined period
7. Alarm Dry Contact
External alarm detecting devices e.g. shock detector, triggered air bag
8. Analog Input High or Low Alarm, & Pulse Input
External sensor devices e.g. temperature transducer alerts user with GPS data
GPS Overview
▪ High precision in location (within 3 meters) and speed (meter per minute)
▪ Logging interval and Upload interval are independent and user programmable
▪ Support international standard NMEA interfacing with other GPS Navigation or Tracking System
▪ Support Google Earth
▪ Server/Client Application Software allows global application with regional services
Sample Application
Tracking:
It keeps users (max. 4 mobile phone & 1 centre) notified of GPS data via both GSM SMS and GPRS network in an user‐
defined interval
Automatic Alarm Report:
Not only alarm is reported by dialing, control centre is informed of the accident location via both GSM SMS and GPRS
network instantly.
Position Lock:
User activates the “Position Lock” on leaving the car in the car park. When the car is moved out of its position, it will
alert user and send the GPS data via both GSM SMS and GPRS network instantly.
GPRS Data Logger [built in GPS] ~ GPS Function
(a) On Schedule
♦ Data is uploaded every interval via SMS or GPRS
♦ User Programmable upload interval
♦ Data records within the interval will be uploaded in packet
(b) Manual Check
♦ Query by user mobile phone SMS
♦ Command from Server via SMS or GPRS
♦ Command via USB by PC software
(c) Alarm Triggered
♦ Digital Alarm Input
♦ Panic Button
♦ Low Input Voltage Level Alert
♦ Analog Input Alert High/Low
e.g. Temperature is too high/low
Oil tank level is too low
(c) GPS Alarm
♦ Fence In, Fence Out
♦ Position Lock
♦ Idle Time
♦ Over Speed
How to get the live and logged data?
Internet: Using PC to receive GPS data via Internet
GSM SMS: Using mobile phone or GSM modem to receive GPS data via SMS
USB port: Using devices with USB port to retrieve GPS data via USB cable
What information is inside the data packet?
♦ Device ID number
♦ Date Time stamp
♦ Power Voltage Level
♦ GPS data
♦ Speed, Location, Heading Degree
♦ GPS alarm status
♦ Digital Alarm Status
♦ Measured Analog values
♦ Measured Accumulated Pulse value
When will GS902 upload data?
Applications
Fire Vehicles Central Management
♦ Tracking fire vehicle water tank level
♦ Tracking fire vehicle position
♦ Alert on low water tank level
Fleet Management of Cold Food Truck
♦ Tracking temperature levels
♦ Tracking truck position
♦ Alert on high/low temperature
GPRS Data Logger [built in GPS] ~ data upload
Specification
Operating Temp: ‐30˚C ~ +70˚C
Standby Temp: ‐50˚C ~ +80˚C
Power Input: DC 9 ~ 24V (recommended DC12V)
Rating: 55mA @12VDC, max. 0.2W
Enclosure: Aluminum Case
Dimension: 100 x 60 x 18 mm
Weight: 92 g
Optional
Recharge Time: 2 hours Full Charge
Battery Backup: 15~20 hours
GPRS & GSM
GSM/GPRS Module
GS902B, GS902S, GS902P
∗ Siemens MC55i
∗ 850/900/1800/1900 MHz
∗ [fixed IP & domain name]
Internal Memory: 1MB
* GPS Antenna
* GSM Antenna,
* USB Cable
* Power Connector
* Microphone Connector
* I/O Connectors
(vehicle installation type)
GPS Chip: GSTAR GS‐89
GPS Band: 1575.42 MHz
GPRS/GSM Chip: Quad Band
GPS Standard: +NMEA protocol
GPS Antenna: External
GPS Accuracy: 3~5 meters
Response Time: max. < 120s, the least < 20s
Start Up Time: Power Up: 20~45s
Standby Mode Wakeup: 15~25s
Normal Mode Resume: 5~8s
Accessories
GPRS Data Logger [built in GPS] ~ specification
Data Capturing Interval 2 seconds
Data Logging Interval Programmable (1 ~ 60 minutes)
Data Upload Interval Programmable (5 seconds ~ 24 hours)
IP Connection Dynamic / Fixed
Protocol TCP
Data Transmission GSM SMS / GPRS Data / USB
Data Upload On Schedule / Manual Request / Alarm Triggered / GPS Alarm
PC Communication Port USB
Internal Data Record Average 30 days (1MB)
Local Setup via USB by PC Software ü
Remote Configuration via SMS or GPRS ü
GPS Chip GSTAR GS‐89
Built‐in Quad Band GSM Module Siemens MC55i GSM 850/900/1800/1900MHz
Bundled Software Free Standard Edition
Setup Software Remote (GSM Modem GS300) & Local (USBport)
Centre Software Support txt database, max. 99 data loggers
UPD Testing Tool available
Optional Software Basic or Premium Edition
GPS Standard +NMEA protocol
Model Selection
GS902B GS902P GS902S
Enclosure Aluminum Aluminum Aluminum
Low Voltage Alert
Power Input: DC 9~24V
Alarm Input 4 3 4
Panic Button 1 1 1
Pulse Input 0 1 0
Relay Output 2 2 2
High Precision AD Channels 2 2 1
Internal Memory 1MB 1MB 1MB
Temperature Sensors — 1 x Submersible [‐55~125 °C]
GPRS Data Logger [built in GPS] ~ select model
How to setup GS902?
[1] Mobile Phone [2] Setup Software
[3] Server Software Premium Edition
How to receive data from GS902?
[1] Server Software Premium Edition
GPRS Data Logger [built in GPS] ~ schematics
Premium Server Software
♦ Receiving data via Internet & SMS remotely and USB
locally
♦ Display of live data and devices status in real time
♦ Maintaining the record database in xml files
♦ Maintaining the database of GPRS data loggers iden‐
tities and properties
♦ Display status of server, data loggers and clients
♦ Interface for user development and application
♦ Alert user via TCP / Email / SMS
♦ Grouping of user/client/email/SMS phone numbers
♦ Client software support
♦ Support of integrating with:
Access / MySQL / SQL / Oracle Databases
GPRS Data Logger [built in GPS] ~ software
Auto Data Recovery Function:
When live data is lost owing to GSM network problem,
Server will automatically retrieve the logged data from
the data loggers once network resumes.
Client Software
Data Logger Client software provides:
♦ Downloading data from Server
♦ Real time monitoring of a number of
data loggers
♦ Alert users when temperature is too
high/low
♦ Alert customers via email, SMS or TCP
♦ Historical data review
Edition Centre Premium
[A] Server Software
Receive Data via SMS — Yes
Receive Data via GPRS Data Yes Yes
Receive Data via USB Port — Yes
Live Data Display — Yes
Database txt
Daily only
Access / MySQL
SQL / Oracle
XML — Yes
Data Export to Excel — Yes
Remote Command via SMS — Yes
Remote Command via Internet — Yes
Schedule Command — Yes
Auto Data Recovery — Yes
Send Alarm Alert via TCP network — Yes
Send Alarm Alert via email — Yes
Send Alarm Alert via SMS — Yes
Alert Users Grouping — Yes
Alert Emails Grouping — Yes
Client Software support — Yes
Max. GPS Trackers simultaneous support 99 9999
GPS Trackers Management — Yes
User Authentication & Management — Yes
Network Client Authentication & Management — Yes
Web Based Access support — Yes
[B] Client Software N.A. Bundled
Live Data Display — Yes
Alarm Alert — Yes
Graphic Display of Temperature & Humidity — Yes
Temperature & Humidity Hi/Low Alert — Yes
Historical Data Access — Yes
SDK for user development — Yes
Temperature & Humidity Alert [GS902S] — Yes
Basic
—
Yes
—
Yes
Access
Yes
Yes
—
—
—
—
—
—
—
—
—
—
—
999
—
—
—
—
—
N.A.
—
—
—
—
—
[C] Bundled GSM Modem — — Yes
Centre Edition is bundled with GPS Tracker free. Basic & Premium Edition are sold separately.
GPRS Data Logger [built in GPS] ~ software