7/26/2019 SIP Support in Cyberoam

http://slidepdf.com/reader/full/sip-support-in-cyberoam 1/1

How To – Allow and Block Emails Using White or Black Lists

Applicable Version: 10.00 onwards

Cyberoam supports Session Initiation Protocol (SIP) for multimedia communication such as VoIP.

Cyberoam SIP Module is enabled by default and provides the following functionalities for SIP traffic:

  Works on UDP port 5060.

  NATing of local IP addresses to public IP addresses.

  Enables a dynamic voice channel by setting up an expected voice connection in the Firewall.

The administrator can disable the SIP module by following the steps mentioned below:

1. Logon to the CLI console and select option 4. Cyberoam Console from the Main Menu list.

2. Execute the following command:

console> cyberoam system_modules sip unload

Note:

To load SIP module again, execute the following command at the console prompt:

console > cyberoam system_modules sip load

Document Version: 1.2  – 30 October, 2014

SIP support in Cyberoam