Simply Beautiful, Beautifully Simple - Jensen...
Transcript of Simply Beautiful, Beautifully Simple - Jensen...
800-243-2000 www.jensendental.com
Simply Beautiful, Beautifully SimpleSimply Beautiful, Beautifully Simple
Exclusively From Jensen Dental
Instruct ions for Use
800-243-2000 www.jensendental.com
Simply Beautiful, Beautifully Simple
Technical Information for InSync TI Titanium Opaques
Technical Data
TYPE
CLAS
SCTE CTE Tg(*) Chem. Solubility 3 Point – Flexural Strength
2x fired(25-500°C)
4x fired(25-500°C)
2x / 4x fired Ceramic acc. to
ISO 6872 Keramik acc. toISO 6872
[*10-6 K-1] ± 0,5
[*10-6 K-1] ± 0,5 [°C] ± 20 [µg/cm2] [µg/cm2] [MPa] [MPa]
Ti-Opaque I 1 9.2 9.2 550 ≤ 30 < 100 ≥ 125 > 50
Framework Fabrication
In order to obtain an optimal bond between the Opaque and the Titanium-framework, please follow the Titanium manufacturer’s indications.
Firing Schedule for Titanium (Recommendations)
Dry Time(min)
Start Temp°C
1st Bake°C
2nd Bake°C
Start Vac°C
Heat rate°C/min
Hold time(min)
Opaque Bake 4 400 800 800 450 55 2
Shoulder Bake 4 400 800 790 450 45 1
Dentin/Incisal 4 400 740 730 450 45 1
Glaze Bakes 4 400 710 ---- 450 45 1
Final Bake without Glaze 4 400 720 ---- None 45 1
Correction Bake 4 400 690 ---- 450 45 1
800-243-2000 www.jensendental.com
Simply Beautiful, Beautifully Simple
1. Mix the Opaque-powder and the opaque liquid to a creamy consistency.
2. Apply the Opaque powder onto the clean framework in a thin and even coat with a glass instrument until an optimal coverage of the framework has been obtained.
FIRST OPAQUE BAKE
1. After the opaque application, place the crown or bridge on a bake tray at a start-up temperature of 400°C.
2. Heat the crown or bridge to 800°C at a rate of 55K per minute and start vacuum at 450°C.
Hold time: 2 minutes without vacuum.
Closing time: 4 minutes
SECOND OPAQUE BAKE
If first opaque application does not provide complete coverage, apply second coat and fire according to instructions for the first opaque bake (800°C)
InSync TI - PROCESSING ON TITANIUM
Basic Build Up Process for Anterior and Posterior Restorations
Follow InSync ZR layering instructions for use for build up processes
800-243-2000 www.jensendental.com
Simply Beautiful, Beautifully Simple
Exclusively From Jensen Dental
Jensen Dental50 Stillman RdNorth Haven, CT 064732015-04-02 Rev. 0
Tel. (800) 243-2000www.jensendental.com
Jensen Technical is available to assist you at1.800.528.5531 or you can visit our educationwebsite at portal.precisodental.com by scanningthe QR code to the right.