SFME
Transcript of SFME
Who We Are?
Sport Floor Middle East aims to provide turnkey solutions to the Sports and Leisure industry in UAE and the region operating since 2009
20+ years of local and international experience and market knowledge.
Successfully providing our expertise with references and backing from several key clients.
Our motto is Dedication, Commitment, Team spirit to achieve customer satisfaction.
What We Do?
Artificial grass for Sports pitches
Artificial grass for landscaping
Acrylic sports surfacing for outdoor sports
Indoor sports hall surfacing
Swimming Pool construction and maintenance
Design and Construction of Leisure facilities such as Steam, Sauna, Jacuzzi
Water features etc.
We Are Known For?
One-stop-shop from supply to installation and maintenance and provide best Sports pitches.
Pioneers in synthetic grass landscaping
Complete range of porous and non-porous acrylic hard court surfaces for basketball/tennis outdoor surfaces.
Broad range of Rubber floorings.
Installation & maintenance of turfs which covers site visits, advice & specialist machinery to ensure the new pitch stays in pristine condition during its life span.
Who We Serve?
Schools/ Colleges/ Universities
(Football/ Tennis/ Basketball etc. courts, Playgrounds,
Running Tracks, Multipurpose surfaces)
Hotels/ Resorts/ Clubs/ Leisure industry.
(Artificial Lawns, Spa, Steam rooms, Sauna, Swimming Pools,
Jacuzzi etc.)
Gymnasiums/ Private Villas etc.
( Gym Flooring, Landscaping, Running tracks etc.)
Properties / Product Advantages?
Resistant to mechanical impact and point loads
Attractive design, Endless colour choice and colour combinations
Maximum light absorbing, Extremely wear resistant
Excellent anti-slip characteristics even when wet
Comfortable cushioning effect, Impact sound absorbing
Affordable choice with long economical life cycle
Easy to install and to maintain
Recyclable, environmentally friendly.
One of our many solution: How Do I Use The Adhesive And Backing Tape? Suitable on all products.
Unroll the two surfaces face up that require joining over lay one on the other by approx 50mm.
Fold back each side down the join by approx 30cm, using a straight edge trim each join edge. Lay the joining tape through the centre of the join. On small lengths up to 4m apply the adhesive on the joining tape and both sides of the surface (approx 6cm into each surface).
Once adhesive has been applied fold over one side of the surface onto the joining tape.
Slowly fold the second side onto the joining tape ensuring a tight join and that no grass tufts are crushed.
Once down using a float or a piece of timber to rub over the join to ensure contact. To ensure contact with the glue place boards or weights along the join. On larger joins work in small sections (approx 2m - 3m) and follow the same instructions above.
How Can I Join The Surface: Surfaces can be joined with tape or adhesive and backing tape both . Suitable on all fiber bonded and some artificial grass products. Unroll the two surfaces face down that require joining, using a straight edge trim both join edges (approx 15-30mm). Push both surfaces together so they form a tight join.
Cutting rolls: Cut with a Stanley Knife (or similar) using a sharp, heavy
duty blade. Mark the cutting line with a pencil and, using a straight edge, cut through the back of the roll, carefully parting the surface pile. A simple paper pattern (or template) should assist in cutting around curves, pipes, doorways etc.
Other way to join : Our surfaces can be joined also with hot melt tapes Use of hot melt tapes: Unroll the 2 surfaces face down that require joining, push both surfaces together so they form a tight join. Lay the hot melt tape glue down over the join. Heat up the tape with a domestic iron so that the glue melts below. When completed turn over the surface.