SERIES - CV5 CHECK VALVE… · SERIES - CV5 Basic Characteristics Approx. Weights Operating...
Transcript of SERIES - CV5 CHECK VALVE… · SERIES - CV5 Basic Characteristics Approx. Weights Operating...
SERIES - CV5
Basic Characteristics
Approx. Weights
Operating Pressure (maximum) - 140 bar (2000 psi)
Rated Capacity - CV5 - 06 / CV5 - ED - 06 = 60 L/min CV5 - 10 / CV5 - ED - 10 = 170 L/min
Seal Kit -CV5 - 06 = VC90028, CV5 - ED - 06 = VC90045CV5 - 10 = VC90046, CV5 - ED - 10 = VC90047
CV5 - 06 = 5.4 kgCV5 - 10 = 11.0 kg
General Description
Pilot pressurePilot pressure required to open valve must be greater than 40% of the imposed pressure at the controlled flow inlet connection.
Filtration25 micron or finer.
Hydraulic fluids0Oil viscosity ranging between 150 and 225 SSU at 38 C is recommended.
These pilot operated check valves operate as a standard check valve and can be opened by remote pilot pressure on the control piston to permit reverse flow. The amount of Pilot Pressure required to open the check is stated as a ratio of the pressure above the check to the pilot pressure
ORDERING INFORMATION
6. Cracking Pressure -HO = 30 psiYH = 75 psiDH = 150 psi
1. Model Code - CV
2. Model Series - 5
4. Nominal Valve Size -06 - 3/4” BSP10 - 1-1/4” BSP
Typical Model Code :- CV5 - 06 - T - HO -10, CV5 - ED - 06 - T - HO -10CV5 - 10 - T - HO -11, CV5 - ED - 10 - T - HO -11
7. Design No. - For 06-10 For 10-11 (Subject to change)
5. Connection Type -T = Thread Connection (BSP)
1 2 3 4 5 6 7
CV 5 - - * T - * *-*-
3. Drain -ED = External Drain (Omit if not required)
PILOT OPERATED CHECK VALVES(THREADED CONNECTION)
35
CV5PILOT OPERATED CHECK VALVES
CV5 -