Security Systems BU Communication Systems ST/SEU-CO 1 DCN SA PO TTU 30.11.2004 Standard Table Top...

6
Security Systems BU Communication Systems DCN SA PO TTU 30.11.20 04 ST/SEU-CO 1 Standard Table Top Discussion Units IFU Manual

Transcript of Security Systems BU Communication Systems ST/SEU-CO 1 DCN SA PO TTU 30.11.2004 Standard Table Top...

Security Systems BU Communication Systems

DCN SA PO TTU30.11.2004 ST/SEU-CO 1

Standard Table Top Discussion Units

IFU Manual

Security Systems BU Communication Systems

DCN SA PO TTU30.11.2004 ST/SEU-CO 2

Standard Table Top Discussion Units

Init / De-Init

Solder spot j1

Solder spot J1 Open (default): Normal

operation Closed: Microphone LED-ring

will begin to flash when the last 60

seconds of speech time remains

NOTE: If J1 is ‘closed’ when the ‘Voice’ activation mode is selected, the microphone LED-ring will remain lit when speaking into the microphone.

Init / De-Init microswitch for resetting the unit’s address

Security Systems BU Communication Systems

DCN SA PO TTU30.11.2004 ST/SEU-CO 3

Table Top Concentus Units

I&O Manual

Security Systems BU Communication Systems

DCN SA PO TTU30.11.2004 ST/SEU-CO 4

Table Top Concentus Units

Type LBB3544 45 46 47

Solder spot 1070

Open (default): Normal operation

Closed: Microphone LED-ring will begin to flash when the last

60 seconds of speech time remains

NOTE: If 1070 is ‘closed’ when the ‘Voice’ activation mode is selected, the microphone LED-ring will remain lit when speaking into the microphone.

Init / De-Init microswitch

for resetting the unit’s address

Init / DE-Init

Security Systems BU Communication Systems

DCN SA PO TTU30.11.2004 ST/SEU-CO 5

Table Top Concentus UnitsFuture prospects not yet available in the SW!

Solder spots 1170Open (default) : Normal operationClosed : The intercom function is no longer available (see Note)

NOTE: If 1170 is closed, the functionality of solder spots 1171 and 1172 is available(for example - an external make contact can be connected to PINS 1 and 2 of the intercom connector for ‘FRAude’ (Fraud push_ button) and ‘FINger’ (Finger print reader) operation.

Solder spots 1171Open (default) : Normal operationClosed : ‘FRAude’ bit is available via the intercom connector (see Note)

Solder spots 1172Open (default) : Normal operationClosed : ‘FINger’ bit is available via the intercom connector (see Note)

NOTE: If solder spot 1170 is closed a choice of only one of the functions is available‘FRAude’ or FINger’ NOT both. FIGURE 2- 11 PCB layout conference (Concentus) units Solder spot

Security Systems BU Communication Systems

DCN SA PO TTU30.11.2004 ST/SEU-CO 6

DCN Table Top Units

End of section

Robert Bosch GmbH

All rights are reserved. Reproduction or passing on to

third parties in whole or in parts is prohibited without the

written consent of the copyright owner.