Section Two REV – 19 JUN 2013 Structural

Picture below shows an example of the locations of the structural equipment for a typical ship. Note: shoring material red dot and the box, plate, and bucket are brown.

AOR showing Shoring layout DCAMS Deck Plan View showing Spread Stowage

(structural Icons yellow)

Shoring Equipment Compartment Diagram Shoring layout with wood shoring, steel shoring (3ft – 5 ft & 6 ft – 11 ft), and metal box patch

Plate patches, bucket patch, and box patch stored in

same location Box patch (not shown are 2 smaller inside larger

box) with plate patches in bracket

Box patch with securing straps

Note the plate patch bracket on right Two box patches different brackets

Box patches (stacked inside are 2 other smaller) in

passage with securing strap Box patches front view

Box patch with securing straps.

Lighter metal with gasket attached. Box patch not secured. Heavier metal with no

gasket. Note: bracket incorrect size.

Box patch with angle iron retainer Box patch brackets

Bucket patches (two)

Mount has rod which extends through buckets Bucket patches (three)

Mount has rod which extends through buckets

Plate patches in a heavy duty bracket Plate patches in bracket

Note: label plate on bracket incorrect.

Folding round plate patch. Note the “J” bolts dangling on angle iron.