Se p Guide –Long Range iMis way/Gen 3€¦ · iMist finds node Name system and Finish. Title:...
Transcript of Se p Guide –Long Range iMis way/Gen 3€¦ · iMist finds node Name system and Finish. Title:...
Install Node on Gen 3
A. Thread antenna cable onto coax connection on node.
B. Secure node to underside of lid with nuts as shown.
C. Push male connector on antenna cable through hole
in lid.
D. Slip o-ring over connector Add washer, then nut and
tighten to press o-ring flush against lid as shown.
E. Thread antenna (marked with yellow rings) onto
connector on top of lid.
Setup Guide – Long Range iMistAway/Gen 3
Plug Node into Controller and Set PAN ID
A. Unplug misting unit and lift controller from
well without disconnecting cables.
B. Thread gray node cable through slot in shroud
and up through controller well as shown.
C. Connect white connector on cable to six pin
port on controller as shown.
D. Restore power to unit and observe boot-up.
Confirm you see NET ON.
E. In DATA menu, select PAN 1. Press and hold
Green button until “1” flashes.
F. Find PAN ID on box label or on gateway label.
G. Enter PAN ID, then Green button to select.
Controller responds with WAIT, then DONE.
Connect Gateway to Internet
A. Locate the modem or router that provides an
internet connection to customer’s property.
B. Thread gateway antenna (black, no markings)
onto coax connector on gateway.
C. Connect gateway to power with adapter. Any
green light indicates power.
D. Connect gateway to customer’s router or modem
with blue ethernet cable.
E. Vertical row of lights to left of ethernet port
indicate strength of connection between gateway
and node, and NOT whether it is connected to
the internet. Turn page for Activation Guide
Gateway
Node
iMistAway Activation Guide
Add Customer
from
iMistAway App
Activate Unit
Check
Connection
Sync Controller
Send Invitation
• Full – website and
dealer app
• Mobile - customer
app only
Search then Select
Search then Select
Name Unit
Select Customer Manager
Select Unit from List
Screen then swipe
Select Activate Unit
Check Connection
(< 1 min)
Start Data Synch
(few minutes)
Send login invitation from
Customer Manager
Input Customer Info Select Access Level Save Customer
Confirm prep steps Begin activation Enter MAC address of gateway
Associate to Customer If gateway is online, iMist
searches for node
iMist finds node Name system and Finish