SD Card Holder - PrusaPrinters...SD Cards and stick them near the printer, when the print finishes...
Transcript of SD Card Holder - PrusaPrinters...SD Cards and stick them near the printer, when the print finishes...
2.37 hrs
1 pcs
f
0.20 mm
k
0.40 mm
h
8
21.00 g
d
PrusaMK3/S
Summary
While I'm waiting for a print to complete I usually load up a few models onSD Cards and stick them near the printer, when the print finishes I pull theold card and put the new in. Sometimes I forget to take the old one awayand end up with it in the pile of 'next' cards. I don't mark my SD cards orname the files on them so I end up clearing the cards and starting again orjust guessing.
I designed this to hold 5 SD cards on my IKEA lack enclosure. This means Ican queue my spontaneous prints and have some form of order.
I mark the enclosure door with the SD card contents (Lack marker holderhere https://www.prusaprinters.org/prints/32754-lack-table-dry-wipe-marker-holder)
When a print is complete I wipe it off (Lack eraser here https://www.prusaprinters.org/prints/32753-lacktable-whiteboard-eraser-holster)
3D Printers > Other Accessories
storage sdcard lack ikealack ikea
Devon Goldstone
SD Card Holder
VIEW IN BROWSER
updated 4. 6. 2020 | published 14. 5. 2020
Print Files (.gcode) DOWNLOAD ALL FILES
1.8 MB
2.37 hrs f 0.20 mm k 0.40 mm h PET 21.00 g d PrusaMK3/S
updated 14. 5. 2020
Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES
57.9 KBupdated 14. 5. 2020
48.3 KBupdated 14. 5. 2020
I was afraid that this would sag and the cards would not fit, so I printed itin the orientation it would be used. This worked out well and I had noissues with my prints.
I don't think the infill is important here, I used 15% I printed in PETG with a0.2mm layer height I used a Prusa i3 Mk3s with the textured steel sheetNo Skirt or brim necessary No supports necessary
License
This work is licensed under a Creative Commons (4.0 International License)
Attribution
5_sd_card_carrier_02mm_petg_mk3s_2h22m.gcode
5_sd_card_carrier.stl
5_sd_card_carrier.3mf
✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✔ | Commercial Use ✔ | Free Cultural Works ✔ | Meets Open Definition