IRJET-Evaluation of low power Schmitt Trigger for communication system
Schmitt Trigger
-
Upload
assini-hussain -
Category
Documents
-
view
709 -
download
6
Transcript of Schmitt Trigger
![Page 1: Schmitt Trigger](https://reader031.fdocuments.us/reader031/viewer/2022012403/5516c273497959f5148b4cc4/html5/thumbnails/1.jpg)
Expt. No. 9
SCHMITT TRIGGER
Objective: To study the operation of Schmitt trigger circuit using BJT.
Components and equipments required:
1. Oscilloscope (Scope/CRO).2. Function Generators (FG).3. DC power supply.4. Project Breadboard. 5. Resistors.6. SL100 BJTs / BEL100N/BC1077. Connection Wires. 8. Oscilloscope Probes.
Circuit diagram:
Fig. 1
![Page 2: Schmitt Trigger](https://reader031.fdocuments.us/reader031/viewer/2022012403/5516c273497959f5148b4cc4/html5/thumbnails/2.jpg)
Theory:
Schmitt trigger is a threshold circuits with positive feedback having a loop gain > 1. The circuit is named "trigger" because the output retains its value until the input changes sufficiently to trigger a change: in the non-inverting configuration, when the input is higher than a certain chosen threshold (UTP), the output is high; when the input is below a different (lower) chosen threshold (LTP), the output is low; when the input is between the two, the output retains its value. This dual threshold action is called hysteresis and implies that the Schmitt trigger possesses memory and can act as a bistable circuit (latch). There is a close relation between the two kinds of circuits that actually are the same: a Schmitt trigger can be converted into a latch and v.v., a latch can be converted into a Schmitt trigger.
(Explanation about circuit: prepare yourself)
Design:
Given that
Upper threshold point (UTP) voltage
Lower threshold point (LTP) voltage
Choose
![Page 3: Schmitt Trigger](https://reader031.fdocuments.us/reader031/viewer/2022012403/5516c273497959f5148b4cc4/html5/thumbnails/3.jpg)
Pre-lab Assignments:
1. Consider the circuit shown in fig.1. Find the Hysteresis voltage of the circuit, if
2. For the input wave shown below, plot the output wave for the circuit in fig.1.
Where Vm=10V
Model Waveforms
Input and Output waveforms:
![Page 4: Schmitt Trigger](https://reader031.fdocuments.us/reader031/viewer/2022012403/5516c273497959f5148b4cc4/html5/thumbnails/4.jpg)
Hysteresis Curve
Hysteresis Voltage VH = VUT - VLT = 2V
Tabular Column
a) For UTP
Vin (V) Vo (V)0.40.81.21.62
2.42.83.23.64
a)For LTP
Vin (V) Vo (V)4
3.63.22.82.42
1.61.2.80.4
(Observe the hysteresis curve on oscilloscope by applying V in as X-axis signal and Vo as Y-axis signal. Put oscilloscope in XY mode)