saleem Laser Printer Notes 7

7/28/2019 saleem Laser Printer Notes 7

1/9

[email protected] WWW.UNLIMITEDTIPS4ALL.BLOGSPOT.IN

LASER PRINTERLASER UNIT PARTS

FUNCTION OF LASER UNIT: - Laser unit generates laser beam and writes the data on theOPC Drum.Laser diode: - Generates laser beam.Reflecting motor: - reflects laser beam towards focusing lens.Focusing lens: - stretchs the laser beam according to the size of OPC drum.Mirror: - this is used for reflecting laser beam towards OPC DRUM.

MAIN PCB (LOGIC CARD)
mailto:[email protected]:[email protected]


2/9


This board is used for connecting printer with pc and receives data for printing. It also controlsthe functioning of printer.

POWER SUPPLY Function SUPPLIESpower to the parts of printer according to the requirement.

PICK UP ROLLER

Used for loading of papers from the tray.


3/9


SPLITER

Its used for splitting of papers as not to load multiple papers.PLUNGER COIL

IT supports pick up roller when it receives signal to load paper for printing.SCR(secondary corona roller)This roller generates static charge which helps to transfer the toner from OPC Drum to paper.

FUSSER UNIT PRESSURE ROLLER: - press the paper against fusser roller.

HEATING LAMP /STRIP: - Used for generating heat and to melt the toner.

Teflon sleeve:-

This unit is used for fusing of toner with the paper, where the heaters generate heat up to200degree Celsius.


4/9


CatridgeOPC DRUM: - organic photo conductive material coated aluminum drum. This is main part ofthe printer where image is written, processed and developed for printing.PCR: - primary corona roller. This is used for charging OPC drum form -400V to -1600VDC.DOCTOR BLADE: - This is used for controlling the level of toner on the magnetic roller.MAGNETIC ROLLER: - This is used for attracting of toner in fresh toner cavity.WIPER BLADE: - This removes the waste toner on OPC Drum which is left out after

transferring.


5/9


LASER PRINTER PRINTING BLOCK DIAGRAM

PRINTING STAGES CLEANING

CHARGING/CONDOTIONING


6/9


WRITING/EXPOSER

DEVELOPING/TONING

TRANSFERRING

FUSING

CLEANINGHere the waste toner which is left on OPC drum is cleaned by the wiper blade and stored in thewaste toner cavity. This process will help to get clean printing.

CHARGING/CONDITININGPCR charges the OPC drum from -400 to -1600vdc, which will help to get negative charge onthe drum.


7/9


WRITING/EXPOSERLASER unit generates laser beam and write the data on the OPC drum. Where the laser has atthat position it gets temporary magnetic properties, which help to attract toner from the magneticroller.

DEVELOPING/ TONINGMAGNETIC ROLLER attracts the toner and doctor blade controls the level of toner after thatOPC drum attracts the toner where the laser beam has fallen on it.


8/9


TRANSFERRINGImage is transferred to the paper with the help of static charge generated by the SCR from the

OPC drum.

FUSINGAs the paper comes in to the fuser unit, pressure roller presses the paper against fuser roller, atthis time toner on the paper will melt and fuse with the paper. Heater temperature will be up to


9/9


200celsies.

saleem Laser Printer Notes 7

Documents

Transcript of saleem Laser Printer Notes 7