SAFETY SCANNING ELIMINATE HAZARDS THRU: RECOGNITION, EVALUATION, CONTROL.
-
Upload
wilfred-dalton -
Category
Documents
-
view
215 -
download
2
Transcript of SAFETY SCANNING ELIMINATE HAZARDS THRU: RECOGNITION, EVALUATION, CONTROL.
SAFETY SCANNINGELIMINATE HAZARDS THRU:
RECOGNITION, EVALUATION, CONTROL
OBJECTIVES
• Become effective “Safety Scanners”– Constantly be looking for hazards– Spot and recognize hazards– Take action to reduce or eliminate
• Understand basic hazards
• Safety is not a Spectator Sport
RECOGNIZING HAZARDS
• Training
• Job Experience
• Familiarity with operation
• Lack of familiarity with area
• Use of safety scanning survey technique
WHAT IS A HAZARD
• Caught in/on/between• Contact by/with• Struck by/against• Fall to surface/below• Slip/Trip
• Over-exertion• Bodily Reaction• Over-exposure• What if?
HOW TO SCAN
• Sweep eyes around work area
• Hazards present?
• Analyze possible/probable results
• React to hazards
• Proceed
TAKE SMALLER BITES
Cannot eat a whole pie at once
1. Look at one shop
2. One wall area of shop
3. One piece of equipment
4. One aspect of that equipment
HAZARDS IDENTIFIED
• Correct Yourself• Contact Building Manager• Refer to Supervisor or Safety • Bring up in Safety Meeting• Refer to Safety Committee• Reduce the Hazard until Fixed
PRACTICE
• Must practice to be effective
• Start with small area and short time
• Increase area and time practiced
• Make it AUTOMATIC