Safe Use of Pallet Racking · made in the rack design. =kg =kg. 75mm CLEAR
Transcript of Safe Use of Pallet Racking · made in the rack design. =kg =kg. 75mm CLEAR
Safe Use of Pallet Racking
AIR002a
All pallet racking systems should have a Load Notice. Please read it carefully. It will show the beam capacity and total bay load permissible under certain parameters.
Repositioning beam levels has an effect on load capacity.
Do not make unauthorised alterations to beam positions.
Beam load capacities are dependent upon the load being “uniformly distributed”. Ensure that pallets are loaded correctly with equal clearances and with equal overhangs. Product should not overhang pallets – unless an allowance for this was made in the rack design.
=kg =kg
75mm CLEAR<3m HIGH
100mm CLEAR3m-6m HIGH
Ensure sufficient lifting clearance for safe loading
FORK ENTRY
Use good quality pallets, correctly orientated and evenly loaded.
Safe Use of Pallet Racking. AIR002a
PTO
MAX ----kg PER BAY
MAXkg
MAX x LEVELS PER BAY
THIS RACKING IS SUITABLE FOR A UNIFORMLY DISTRIBUTED LOAD OF 2000kg PER LEVELPROVIDED THAT:1) THERE IS MORE THAN ONE LEVEL OF BEAMS PER BAY2) THERE ARE NO MORE THAN 4 LEVELS OF BEAMS PER BAY3) THE PITCH OF BEAM LEVELS IS NO GREATER THAN 2000mm4) THE RUN LENGTH IS GREATER THAN THE RACK HEIGHT -SEE BELOW
ANY CONFIGURATION OUTSIDE OF THE ABOVE PARAMETERS WILLREQUIRE A SITE SPECIFIC LOAD NOTICE
BEAM PITCH2m MAX
MAXkg
MAXkg
MAXkg
MAXkg
MAXkg
MAXkg
MAXkg
H
L<HL<HL>HL>H
H
RUN LENGTH L
BEAM PITCH2m MAX
BEAM PITCH2m MAX
BEAM PITCH2m MAX
IF IN DOUBT CONTACT YOUR SUPPLIER 01825 686800
Beams will deflect under load.
Ensure that deflection is within acceptable limits – usually beam span/200 for free roaming trucks
e.g. 2700mm beams may deflect up to ……13.5mm at mid-span.
Pallets must be lowered vertically to ensure the load is evenly
transmitted to both beams
Conduct regular checks for alignment and damage to all components.
Damaged Beams or damaged frame bracing must be replaced
Upright posts must be replaced if damage distortion is more than 5mm per 1m length laterally or 3mm per 1m length in the depth,.
DAMAGED RACKING MUST BE REPORTED AND OFFLOADED IMMEDIATELY.
Ensure all safety pins are located. 10
00 5 3
1000
Safe Use of Pallet Racking. AIR002a
Pallets must be lifted cleanly, without dragging or pushing beams
Rapid Racking Ltd
01285 686800
rapidracking.com