Roller Coaster™

Installation Guide

www.highwayproducts.com

Roller Coaster™

Supplied Material List• 6 3/8" rubber washer• 6 3/8 - 16 X 1-1/2" hex head bolts

• 6 3/8 - 16 rev lock nuts• 6 3/8" flat washer

• 9/16” socket• 9/16” wrench • rubber mallet

• drill• tape measure• 1/4" pilot drill bit

• 3/8" drill bitTools Needed

1. Un-crate Roller Coaster 2. With the help of others, place Roller Coaster in bed of truck

3. Place Roller Coaster all the way up against the cab side of bed

4. Slide the tray out to the second click

5. Move the unit so the it is flush with cab side of bed6. Make sure holes in the “Rear Flange” line up with the up slope of the corrugated bed

5

6

7. Center the unit by measuring from side of bed to edge of unit

8. Measure both sides multiple times to insure a centered install

9. Some trucks have a cross member or fuel tank under the bed10.Inspect the undercarriage of your vehicle so you don’t drill through cross member or

fuel tank

11.Drill a pilot hole on the upside of the corrugated bed 12.Inspect, then drill 3/8" hole13.Place rubber washer between the bottom of flange and bed of truck14.Insert 3/8" bolt through Roller Coaster and bed of truck

15.Drill a pilot hole on the other side16.Inspect, then drill 3/8" hole17.Place rubber washer between the bottom of flange and bed of truck18.Insert 3/8" bolt through flange and bed of truck

19.One person under the vehicle with 9/16 wrench, flat lock washers and lock nuts20.Place flat lock washer on the bolt showing underneath truck bed, place nut on bolt, and

fasten.

21.Tighten down both bolts

22.Pull the tray out just far enough to see the middle mounting plates23.There are 4 mounting brackets (1 bolt for each bracket) drill on the up slope of bed24.Insert bolts, washers and nuts25.Tighten down all bolts

We Will Help You

Questions?

www.highwayproducts.com

800-866-5269