Materials21” Chain 3.5mm Rhinestone Trim1 Pair of Ear Wire Hooks 1 Extender 4 Cup Connector 10 Open Jump Rings 4mm 2 Open Jump Rings 6mm

2 Chain Nose Pliers Wire Cutters

1. Cut off 7” of the rhinestone trim (approximately 26 rhinestones), and two 7” lengths of the chain. 2. Place the ends of the rhinestone trim in cup connectors and secure by bending the prongs on either sides.3. Open 6 of the 4mm jump rings. Hook on to each ends of the rhinestone trim and both 7” chains.4. Remove the lobster clasp from the end of the extender. Shorten the extender to 12 links.

jump ring and hook it to the 4mm jump rings on the ends. Hook on the extender before closing the jump ring.6. Take the other jump ring and hook onto the 4mm jump rings on the other side of the trim and chains. Add the lobster clasp before closing the jump ring.

Bracelet

1. Cut 2 lengths of 2” chains, 2 lengths of 1.5” chains and 2 lengths of rhinestone trim 4 stones in length.2. Attach a cup connector to one end of each of the rhinestone trim and secure.3. Open the remaining 4mm jump rings.4. Hook on the 2” chain, the 1.5” chain and the rhinestone trim facing away from the chains. Close the jump ring. Hook this 4mm jump ring to another open 4mm jump ring and add an earring wire hook. Close the jump ring. 5. Repeat step 4 for the other earring.

Earrings

Rhinestone Bracelet and Earrings

blog.fabricland.ca