RF-008 - Reversible Slate Roof - Dwarven Forge · STONE DOOR WALL. Painting Guide. Lightly Dry...
8
Side 2 Side 1 BASE WOOD (GT002-BW) Step 1 Side 2 Side 1 Step 2 Side 2 Side 1 Step 3 RF-008 - Reversible Slate Roof Page 1 of 3 Apply Base Gray, Basalt Blue and Cavern Stone Dry Brush in a 2:2:1 mixture as a heavy dry brush over the entire surface of the roof and lower slate shingles with a #3 (Painting) brush. Be careful not to apply too much paint. Avoid the crack of piece while dry brushing to bring out the texture in the piece. Let the paint dry before moving to the next step. Dab a very small amount of a mixture of Stone Edge Dry Brush, Basalt Blue and Base Gray in a 2:2:1 ratio onto a #12 (Drybrush) brush, and brush onto a paper towel to remove excess paint. With an extremely light touch, apply over the entire surface of the shingles to bring out the mid tones. Let the paint dry before moving to the next step. Step 4 Side 2 Side 1 RF-008 - Reversible Slate Roof Painting Guide BASE GRAY (GT002-BG) Apply Base Wood over the wooden beams and window trim with a #3 (Painting) brush. Be careful not to apply too much paint. Use a light hand (avoid painting into the deeper areas) to bring out the texture. Let the paint dry before moving to the next step. Dab a very small amount of a mix of Stucco, Earth Stone and Base Wood in a 2:2:1 ratio on a #12 (Drybrush) brush, then dab the brush onto a paper towel to remove excess paint. With a feather light touch, dry brush over the surface of the wood, to create highlights. Let the paint dry before moving to the next step. BASALT BLUE (GT002-BASB) CAVERN STONE DRY BRUSH BASALT BLUE (GT002-BASB) STONE EDGE DRY BRUSH (GT002-SE) (GT002-CD) STUCCO (GT002-ST) EARTH STONE (GT002-ES) BASE WOOD (GT002-BW) + + + + +
Transcript of RF-008 - Reversible Slate Roof - Dwarven Forge · STONE DOOR WALL. Painting Guide. Lightly Dry...
Side 2Side 1
BASE WOOD(GT002-BW)
Step 1
Side 2Side 1
Step 2
Side 2Side 1
Step 3
RF-
008
- R
ever
sibl
e Sl
ate
Ro
of
Pag
e 1
of
3
Apply Base Gray, Basalt Blue and Cavern Stone Dry Brush in a 2:2:1 mixture as a heavy dry brush over the entire surface of the roof and lower slate shingles with a #3 (Painting) brush. Be careful not to apply too much paint. Avoid the crack of piece while dry brushing to bring out the texture in the piece. Let the paint dry before moving to the next step.
Dab a very small amount of a mixture of Stone Edge Dry Brush, Basalt Blue and Base Gray in a 2:2:1 ratio onto a #12 (Drybrush) brush, and brush onto a paper towel to remove excess paint. With an extremely light touch, apply over the entire surface of the shingles to bring out the mid tones. Let the paint dry before moving to the next step.
Step 4
Side 2Side 1
RF-008 - Reversible Slate Roof
Painting Guide
BASE GRAY(GT002-BG)
Apply Base Wood over the wooden beams and window trim with a #3 (Painting) brush. Be careful not to apply too much paint. Use a light hand (avoid painting into the deeper areas) to bring out the texture. Let the paint dry before moving to the next step.
Dab a very small amount of a mix of Stucco, Earth Stone and Base Wood in a 2:2:1 ratio on a #12 (Drybrush) brush, then dab the brush onto a paper towel to remove excess paint. With a feather light touch, dry brush over the surface of the wood, to create highlights. Let the paint dry before moving to the next step.
BASALT BLUE(GT002-BASB)
CAVERN STONE DRY BRUSH
BASALT BLUE(GT002-BASB)
STONE EDGE DRY BRUSH
(GT002-SE)
(GT002-CD)
STUCCO(GT002-ST)
EARTH STONE(GT002-ES)
BASE WOOD(GT002-BW)
+
+
+
+
+
Step 5
CARDBOARD(GT002-CB)
Side 2
Side 2
Step 7
Step 6
Step 8
RF-
005
- R
ever
sibl
e T
err
aco
tta
Ro
of
Pag
e 2
of
3
Base Gray(GT002-BG)
Using a #3 (Painting) brush, Apply Base Gray with a few drops of Basalt Blue over the surface of the stones on side 2, avoiding the wood trim of the window. Let the paint dry before moving to the next step.
Side 2
Apply Cardboard to random stones on the stone facing using either a #3 (Painting) or a #1 (Details) brush. This will add further texture and interest to the stones. Let the paint dry before moving to the next step.
Dab a very small amount of Stone Edge Drybrush onto a #12 (Drybrush) brush, then dab the brush onto a paper towel to remove excess paint. With a feather light touch, apply the color over the en- tire surface of the stone facing and slate shingles to create highlights. Let the paint dry before moving to the next step.
Side 2Side 1
RF-008 - Reversible Slate Roof
Painting Guide
BASALT BLUE(GT002-BASB)
+
STONE EDGE DRY BRUSH
(GT002-SE)
SHALLOW WATERSEAWEED GREEN
(GT002-SG)
ARCANE ACID(GT002-AA)
+
Apply Shallow Water Seaweed Green with an optional few drops of Arcane Acid for a brightening effect. to the mossy areas on the roof using a #1 (Details) brush. Let the paint dry before moving to the next step.
To add more dimension lightly dry brush Moss Green over the moss after the previous green paint has dried.
(optional)MOSS GREEN
(GT002-MG)
BLACK(GT002-B)
Side 1
Step 10
RF-
005
- R
ever
sibl
e T
err
aco
tta
Ro
of
Pag
e 3
of
3
Apply a mixture of Stucco, Stone Edge Dry Brush and Lava Yellow 3:3:1 ratio over the entire surface of the stucco using a #1 (Detail) brush.
Feel free to apply the paint into the indentations, since this area will have a wash to bring out the natural imperfect- tions in the stucco. Or use a light touch, if you prefer, to enhance the texture. Let the paint dry before moving to the next step.
Side 1
RF-008 - Reversible Slate Roof
Painting Guide
Apply a light wash of Black and Earth Stone in a 2:1 ratio to the entire surface of the stucco using a wet #12 (Drybrush) brush. Immediately and gently wipe off the excess paint with a paper towel, leaving some of the paint behind.
If you prefer a lighter stucco, you can skip this step.
Note: Use the same approach for your other Slate Roof pieces shown here:
Slate Full RoofRF-002
SlateBalcony Cover
RF-003
Slate GableRF-05
Step 9STUCCO
(GT002-ST)
STONE EDGEDRY BRUSH(GT002-SE)
+
LAVA YELLOW(GT002-LY)
+
EARTH STONE(GT002-ES)
+
Side 2
Side 1
Step 1
Side 2
Side 1
Step 2
Side 2
Side 1
Step 3W
L-00
5 St
on
e C
ente
r W
ind
ow
Wal
l Pa
ge
1 o
f 2
WL-005 - Stone Center Window Wall
Painting Guide
BASE GRAY(GT002-BG)
Using a #3 (Painting) brush, apply a mixture of Base Gray plus a 1-2 drops of Basalt Blue over the entire surface of the stones on both sides. Use a light touch, leaving the deeper areas unpainted to bring out the texture. Let the paint dry before moving to the next step.
Apply Cardboard to random stones and the window trim on both sides using a #1 (Detail) brush. This adds variety to the stones. Let the paint dry before moving to the next step.
Dab a very small amount of Stone Edge Drybrush onto a #12 brush, then brush onto a paper towel to remove excess paint. With a feather light touch, apply over the entire surface and edges to high- light the surface of the stone.
BASALT BLUE(GT002-BASB)
+
CARDBOARD(GT002-CB)
STONE EDGE DRY BRUSH
(GT002-SE)
Bridge of Valor ST-014
WL-005 - Stone Center Window Wall
Painting Guide
Note: Use the same approach for your other stone pieces shown here:
Fireplace AC-038
Stone Solid WallWL-004
Stone Door WallWL-006
Stone Magnetic WallWL-008
Arrowslit WallWL-009
Abbey Window Wall
WL-010
Stone Off et Window Wall
WL-013
Stone Torch WallWL-006
Dungeon Passage 1-PS1
Stone PostPT-002
Stone Gargoyle Post
AC-040
Stone DoubleCorner Post
PT-005
Stone DoubleDoor WallWL-011
WL-
005
Sto
ne
Cen
ter
Win
do
w W
all
Pag
e 2
of 2
Step 1
Step 2
Step 3W
L-00
6 St
on
e DOOR
Wal
l Pa
ge
1 o
f 1
WL-006 - STONE DOOR WALLPainting Guide
Lightly Dry Brush Basewood over the doors texture using a #3 brush. Let this dry before moving on to next step
With an even lighter feather touch than before dry brush a mixture of Stucco, Earth Stone and Base Wood in a 2:2:1 ratio
Paint all metal details on door with Sysuul Silver. You can base coat the details first with Black so that the metallic will really pop.
SYSUUL SILVER(GT002-SYSS)
STUCCO(GT002-ST)
EARTH STONE(GT002-ES)
BASE WOOD(GT002-BW)
+
+
BASE WOOD(GT002-BW)
(optional)BLACK
(GT002-B)
Step 2
FL-0
02 -
Sto
ne
Flo
or
Pag
e 1
of
2
Step 1
Step 3
Apply a mixture of Base Gray and Stone Edge Dry Brush in a 1:1 ratio with a few drops of Basalt Blue. over the entire surface and edges of the piece with a #3 (Painting) brush. Let the paint dry before moving to the next step.
Using either a #1 (Details) or a #3 (Painting) brush, paint a few stones a slightly darker color by mixing Base Gray with Black. This will add more variation to your floors. Let the paint dry before moving to the next step.
Apply Cardboard to random stones on using a #1 (Details) or a #3 (Paint- ing) brush. This will add even better variation to your floors. Let the paint dry before moving to the next step.
FL-002 - Stone Floor
Painting Guide
BASE GRAY(GT002-BG)
BASALT BLUE(GT002-BASB)
STONE EDGE DRY BRUSH
(GT002-SE)
+
+
BASE GRAY(GT002-BG)+
BLACK(GT002-B)
CARDBOARD(GT002-CB)
Step 5
FL-0
02 -
Sto
ne
Flo
or
Pag
e 2
of
2
Step 4
FL-002 - Stone Floor
Painting Guide
Dab a very small amount of Cavern Stone Drybrush onto a #12 (Drybrush) brush, then brush onto a paper towel to remove excess paint. With a feather light touch, apply over the entire surface and edges of the piece to bring out the high- lights. Let the paint dry before moving to the next step.
Apply a light coat of Stone Edge Drybrush (very diluted with water) to the entire surface of the floor using a wet #12 (Drybrush) brush. Be sure to get the paint into the cracks between the stones. Immediately and gently wipe off the excess paint with a paper towel, leaving some of the paint behind.
Pro Tip: Use an alternate weathering color such as White instead of Stone Edge Drybrush.
If you prefer darker floors, you can skip this step.
Note: Use the same approach for your other Stone Floor pieces shown here:
Stone Stairwell FloorFL-004
Stone Floor with Trapdoor FL-006
CAVERN STONE DRY BRUSH(GT002-CD)
STONE EDGE DRY BRUSH
(GT002-SE)
