LANDING WHEEL FOR MOTOR BIKES

PRESENTED BYF.MOHAMED REYAZ N.SAHAYA REJO

GUIDED BYMR. SIVA

INTRODUCTION This system enable the paraplegic rider to ride two wheeler by acting as a leg for the rider ( i.e) when the vehicle come to stop the supporting wheels come lower to the ground,enabling the bike to stand upright when the bike speed up again the wheels will retract.

OBJECTIVE

Acts as the leg for the paraplegic riderCompact then the other handicapped bikesFlexible to lean the bike in direction of turningCost effectiveFuel efficientNecessity of stand negligibleThis also can be used by common riders

WORKING PRINCIPLEThe speed of the rear wheel is sensed by the proximity sensor and the sensor sends the amount of voltage according to the speed of the wheel and it is calculated by the programmable controller and it operate the control volve of the 15 cm stroke pnuematic actuater and make the actuater to pull in when the speed reaches 15km/hr and push down the system when the speed come down to 15km/hr. The actuater is powered by 250psi 12v compressor which is connecteble to the battery of bike.

The actuater is powered by 250psi 12v compressor

VIEW OF SYSTEM IN BIKE