Rev 3.09 1

LABORATORY

PRACTICAL

Rev 3.09 2

SECTIONS

1. PERFORMING EVIDENTIAL BREATH ALCOHOL TEST

2. ERROR MESSAGES3. FUNCTION KEYS4. RESET SWITCH

Rev 3.09 3

SECTION I: PERFORMING

EVIDENTIAL BREATH ALCOHOL TEST

1.1. EACH STUDENT MUST PERFORM THE TWO SIMULATOR EACH STUDENT MUST PERFORM THE TWO SIMULATOR “INTOXICATED” SUBJECT TESTS “INTOXICATED” SUBJECT TESTS (DRUNK B,&C)(DRUNK B,&C)

2.2. USE INFORMATION IN EACH SCENARIO FOR DATA ENTRY USE INFORMATION IN EACH SCENARIO FOR DATA ENTRY QUESTIONSQUESTIONS

3.3. FOLLOW FOLLOW STANDARD OPERATING PROCEDURESTANDARD OPERATING PROCEDURE MINUS MINUS 20 MINUTE WAIT PERIOD20 MINUTE WAIT PERIOD

4.4. KEEP SIMULATORS PLUGGED INTO AC OUTLETSKEEP SIMULATORS PLUGGED INTO AC OUTLETS

5.5. OBSERVE INSTRUMENT OPERATION AND DISPLAY OBSERVE INSTRUMENT OPERATION AND DISPLAY MESSAGES DURING THE TESTMESSAGES DURING THE TEST

Rev 3.09 4

SECTION I: DRUNK A, B & C CONNECTIONS

1. CONNECT SIMULATOR DRUNK TO INTOXILYZER AS SHOWN IN SLIDE #6

2. DO NOT CONNECT THE SIMULATOR UNTIL DISPLAY READS PLEASE BLOW/R

3. DISCONNECT THE SIMULATOR FROM INTOXILYZER WHEN FINISHED BLOWING

Rev 3.09 5

SECTION I: DRUNK A, B & C CONNECTIONS

Attach Simulator to Intoxilyzer Breath Tube

INTOXILYZER 5000EN

Rev 3.09 6

SECTION II: ERROR MESSAGES

1. INSTRUCTOR MAY RUN ERROR MESSAGES OR STUDENTS MAY ROTATE IN TURN TO CONDUCT ERROR MESSAGES

2. FOLLOW DIRECTIONS IN MANUAL FOR GENERATING EACH ERROR MESSAGE

3. OBSERVE INSTRUMENT OPERATION AND DISPLAY MESSAGES

Rev 3.09 7

SECTION III: FUNCTION KEYS AND RESET

SWITCH1.1. FOLLOW THE DIRECTIONS IN THE FOLLOW THE DIRECTIONS IN THE

SECTION FOR F1,F2, F5 AND F6 OPTIONSSECTION FOR F1,F2, F5 AND F6 OPTIONS

2.2. INSTRUCTOR WILL DEMONSTRATE THIS INSTRUCTOR WILL DEMONSTRATE THIS SECTIONSECTION

3.3. INSTRUCTOR WILL TRIP RESET SWITCH TO INSTRUCTOR WILL TRIP RESET SWITCH TO DEMONSTRATE INTOXILYZER RESET DEMONSTRATE INTOXILYZER RESET PROCEDUREPROCEDURE

Rev 3.09 8

Go to Operator Practical