RENAULT MEGANE 3 (2008 - 2011) MKi + CK (EN_USA).pdf

MEGANE

This document is a tool to assist with the installation of a Parrot product and is supplied purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

MEGANE 3

Installation manual: Parrot MKi + Parrot CK3100 range

The brand name RENAULT MEGANE III and the RENAULT logo are the property of RENAULT. This document is only valid for the vehicle model MEGANE III® year 2008 to 2011, excluding all other models in the same range and excluding later modifications made to the vehicle by the manufacturer. The Parrot brand name and logos are the exclusive property of Parrot SA.

MEGANE


Accessories required

Disassembly 30min

Mounting kit 30min

Refitting 30min

Testing 15min

Total 1h45min

NO +APC

NO ISO

N/A UNIKA

FRONT LOUDSPEAKER TEL mode

ALL MUSIC mode

Fitting time (estimated) / Main features

Tools

-TORX screwdriver - Cutting pliers

- Crimping pliers - Multimeter or Test lamp

- Wire tie - Electrical tape

- Round male terminal

"Please contact your wholesaler to purchase accessories. List of wholesalers available at

www.certified.parrot.com." »

Kram ref. Dealer ref.

CK range 86795 77 11 428 303

MKi range 84795X795 77 11 428 303

Photos for illustration purposes

CK range MKi range

To get the most out of your hands-free kit, we recommend that you update your software regularly. The procedure for doing this can be found at http://www.parrot.com/usa/support/downloads

Updating

Plastic trim removal tools FACOM / BOJO

FACOM DX-25 kit (n°4 tools)

http://www.certified.parrot.com/

http://www.parrot.com/usa/support/downloads



MEGANE


Disassembly

MEGANE


Disassembly 1 / 2

Using the plastic trim tools, unclip the cover above the glove box

Using the plastic trim tools, unclip the cover next to the steering wheel

Using the plastic trim tools, unclip the radio and air conditioning covers...

...pull it out without disconnecting, insert the

removal tools into the slots on each side of the radio

1

3

2

4

5 6

Unlip the radio, pull it carefully, then remove the removal tools

Pull and lift the radio disconnecting the connector and

the antenna

MEGANE


Disassembly 2 / 3

Using the plastic trim tools, unclip the cover located on the right side

of the dashboard

Disconnect the connector for the passenger air bag trigger

Unscrew screw 1 from the glove box

Unscrew screw 2 from the glove box

7

9

8

10

11 12

Unscrew screws 3, 4 and 5 located above the glove box

Unscrew screw 6 in the glove box near the light

1 2

3 4 5

6

MEGANE


Disassembly 3 / 3

9 10

Pull the glove box hard to unclip it, then remove it unplugging the

light connector

Using the plastic trim tools, unclip the central air vent assembly

Remove the assembly without disconnecting it

Using the plastic trim tools, unclip the cover located on the

left side of the dashboard

13

15

14

16

17 18

Remove screws 7 and 8 Using the plastic trim tools, unclip the headlight adjuster and

disconnect it

7

8

MEGANE


Finding an ACC wire 1/2

Remove the large black connector located under the fuse box, under

the steering wheel

Remove the thin YELLOW wire from the bottom row of the black

connector

1 2

9 10

Using a jumper or splice, connect a wire

Pass the wire under the steering wheel to the central air vent

assembly

3 4

5 6

Run the wire into the vents Pass the wire into the glove box housing

MEGANE


Finding an ACC wire 2/2

On the adapter 86795 or 7711428303, cut the red wire

between the fuse holder and the ISO connector and connect the

+APC wire

Swap the fuse holders, i.e. the red and orange wires

7 8

9

On the adapter 84795X795, reconnect the +APC wire using a

round male terminal

MEGANE


Microphone passage

Using the plastic trim tools, pass the cable through the headliner

near the rain sensor

Glue the supplied bracket under the rain sensor cover, after

degreasing

Using the plastic trim tools, run the cable under the head liner and down the windscreen post

Run the cable replacing the seal on the passenger door

1

3

2

4

5 6

Pass the cable into the dashboard on the right side

Run, and attach with wire ties, the cable under the dashboard in

the glove box housing

MEGANE


Feeding the accessory cable

In the bottom of the glove box, insert the cable into the hole next

to the light...

... and bring it out leaving sufficient length

1 2

MEGANE


Fitting the hands-free system 1 / 2

Connect the adaptor to the original connector and connect all of the wires to the blue box as shown in the diagram below. Test the assembly

before reassembly then slide all the cables behind the glove box and attach them with wire

ties

1

ISO adapter

MEGANE


Fitting the hands-free system 2 / 2

Pass the cable through the centre air vent assembly

Bring the wire out in the glove box housing

Glue the support (supplied) after degreasing the upper left corner

of the vent located on the dashboard

2

4

3

12

Re-clip the centre air vent assembly (ATTENTION do not cut

the screen cable)

4

!

MEGANE


Testing

Before refitting the system, switch the kit on using the ignition (or by starting the car). By pushing the central knob

of the remote control, check:

1 - that the menu is displayed on the screen (language or iPod etc) 2 - that the radio system is muted when the kit is in use (click in the blue box) 3 - that the sound through all speakers is properly muted 4 - that there is sound through the front speakers for spoken menus 5 - then turn off the ignition, verify that the kit turns off and that the message “goodbye” is displayed on the screen (otherwise reverse the fuses on the kit power supply harness) 6 - pair a telephone with the kit and make a call (check that both the microphone and the kit are working)

MEGANE


Reassembly

Refit the system using the following procedure: 1 - reconnect and replace the radio 2 - replace the glove box by pushing hard (pay attention to the accessory cable) 3 - replace screws 1, 2, 3, 4, 5 and 6 in the glove box 4 - reconnect the passenger airbag selector 5 - refit the right dashboard panel 6 - replace the cover located below the steering wheel by pushing hard 7 - replace screws 7 and 8 8 - reconnect and replace the headlight adjuster 9 - refit the panel on the left-hand side of the dashboard 10 - refit the car stereo and air conditioning surround 11 - replace the steering wheel side cover 12 - replace the cover above the glove box

RENAULT MEGANE 3 (2008 - 2011) MKi + CK (EN_USA).pdf

Documents

Transcript of RENAULT MEGANE 3 (2008 - 2011) MKi + CK (EN_USA).pdf