Railroad Shunt Systemrailteksafetyproducts.com/wp-content/uploads/2017/... · Brooks model...
2
Contact: Robert H. Fletcher | Office: 610-558-1313 | Cell: 484-343-2141 | [email protected] www.railteksafetyproducts.com Railroad Shunt System
Transcript of Railroad Shunt Systemrailteksafetyproducts.com/wp-content/uploads/2017/... · Brooks model...
-
Contact: Robert H. Fletcher | Office: 610-558-1313 | Cell: 484-343-2141 | [email protected]
www.railteksafetyproducts.com
Railroad Shunt System
-
Product Specifications #1 For Continuous Shunting
Brooks model MB558112; install on front and rear railgear. The entire unit, including brushes, must be stainless steel.Brushes must have the ability to be replaced easily. Must include non-insulated angle mounting brackets with stainless steel mounting hardware.This system shall allow for shunting 100% of on rail operation.
Product Specifications #2 For Engage and Disengage
Brooks model MB558112; install on front and rear railgear. The entire unit, including brushes, must be stainless steel.Brushes must have the ability to be replaced easily. Must include insulated angle mounting brackets with stainless steel mounting hardware that include insulated bushings and washers.This system must have the ability to engage and disengage through a solenoid actuated switch that is mounted on the vehicle or equipment control panel.The Railgear Manufacturer must install insulated wheels on at least one side of the railgear for this option.
Contact: Robert H. Fletcher | Office: 610-558-1313 | Cell: 484-343-2141 | [email protected]
www.railteksafetyproducts.com
Railroad Shunt System
