QUIET-RIOT ® US PATENT #7,896,128 REV 08/03/15Installation Instructions:QUIET-RIOT is intended for installation in straight pipes or in stock pipes with the baffles removed. QUIET-RIOT performanceenhancing exhaust baffles are custom made for your pipe. We typically size the baffle .015” - .020” under the dimension you gaveus for your pipe. This is to insure that the baffles will fit, even if the pipe is a little out of round or there is some carbon buildup inthe pipe.In order to install QUIET-RIOT, you will need a drill with a ¼” diameter drill bit, a center punch, and a set of Allen wrenches. If youare not comfortable measuring locations and drilling holes in your pipes, your local dealer or motorcycle mechanic can easilyinstall these for you following these instructions.

QUIET-RIOT is designed to be installed with the mounting hole four to five inches from the end of your pipe. If you have pipe tipsor mounting bracket penetrations, etc. they can be installed up further, but we recommend no further up than 6” from the end ofthe pipe.

To begin, verify that QUIET-RIOT will slip inside your pipe freely. Next, measure up your pipe on the outside up 5.0”, and place amark. The best place for the mounting bolt is on the bottom side of the pipe, where it is hidden. If you have to have it rotatedslightly to clear a bracket or get access to the hole for both drilling and access to the mounting bolt, that’s ok, as QUIET-RIOTdoes not have a preference how it is rotated.Be sure that you have carefully chosen the position for the mounting bolts (one in each pipe (or just one if this is a 2 into 1system)), and marked your pipe. Get this step right, as you do not want to have more than one hole in your pipe, and once it isdrilled, it is drilled for good.With a center punch, lightly punch the mark you made, just enough to get an indent so the drill won’t walk. Using the ¼” drill bit,drill through the pipe, perpendicular to the pipe, then de-burr the hole with a screwdriver blade or something similar so that youhave a clean hole in each pipe.

Once the holes are drilled and deburred, slide QUIET-RIOT up your exhaust (as shown below), until the hole in the side of thebaffle matches up with the hole you have drilled. You can use a set of needle nose pliers to hold the end while you push it up thepipe.

1

QUIET-RIOT being slid up the pipeSTOP! You MUST USE ONLY THE INCLIDED PALM LABS Turbo-Lock High

Temperature, High Strength threadlocker to mount Quiet-Riot.Next, using the included thread lock, coat the thread on the ¼” button head cap screw and lock washer provided with QUIET-RIOT, insert it into the hole in the pipe that you drilled.

Next, using an Allen wrench, tighten the button head cap screw to between 35-40 inch pounds. With a small Allen wrench suchas what is shown in the above picture, you can tighten it sufficiently without damaging the threads on QUIET-RIOT.

Initial tightening of the QUIET-RIOT mounting bolt.Once QUIET-RIOT has been installed, and the bolts tightened, and the thread lock has cured for 24 hours, you are ready toride! You should feel a substantial improvement in midrange over straight pipes, and the bike will be quieter with a throatierrumble.

Please call us if you have any questions during installation, we will be happy to assist you.

Enjoy your QUIET-RIOT®!Rocky Mountain Performance

217 Racquette, #5Fort Collins, CO, 80524

970-217-1623www.rocky-mountain-performance.com

2