Quick Install Guide of HD UHF Module
1
3 rd Party UHF Module Installation Quick Install Guide 1. Disconnect power code from power outlet. 2. Remove Top cover. 3. Connect cables to Tuner Board. Note J5 is already there keep other cable for spare 4. Insert the Tuner Board to tuner hole at rear cover. 5. Assemble washer, nut & screw. Note plastic filler (on back is NOT needed after module is installed) put it up (it is not USED) 6. Connect cables to main board. 7. Connect the antenna cable from IF OUT to UHF REMOTE ANTENNA. 8. Assemble the Top cover. J4 J5 Washer & nut Screw J902 J901 IF OUT UHF REMOTE ANTENNA Right & Left Screw position Rear Screw position
description
fta sattelit systems
Transcript of Quick Install Guide of HD UHF Module
-
3rd Party UHF Module Installation
Quick Install Guide
1. Disconnect power code from power outlet.
2. Remove Top cover.
3. Connect cables to Tuner Board. Note J5 is
already there keep other cable for spare
4. Insert the Tuner Board to tuner hole at rear
cover.
5. Assemble washer, nut & screw. Note plastic
filler (on back is NOT needed after module is
installed) put it up (it is not USED)
6. Connect cables to main board.
7. Connect the antenna cable from IF OUT to
UHF REMOTE ANTENNA.
8. Assemble the Top cover.
J4 J5
Washer & nut Screw
J902 J901
IF OUT
UHF REMOTEANTENNA
Right & Left Screw position
Rear Screw position