Project-Mohit Suri
-
Upload
mohit-suri -
Category
Engineering
-
view
44 -
download
0
Transcript of Project-Mohit Suri
Project Presentation 5-LINK ROBOTIC DESIGN AND SIMULATION
Mohit SuriME 597
Project Goal To design and simulate a 5 link robotic manipulator/arm capable
of pick, place and other applications.• Creo was used to design the robot • Matlab-Simulink was used to create a simulation environment for
the model. The robotic arm was designed to• Have multiple control loops i.e. individual for every joint.• Use kinematics and feedback control to drive from one point to
another.
Design Creo was used to design every component of the robot. Angular constraints were applied during this process.• <170, • -20< <55 • 25< <100• -15< <10• -20< • = 200mm, = 160mm, = 37.5mm
Tell you the Range or workspace using a Test signal with the DH conventions being applied.
Model Conversion For Simulation
Matlab-Simulink Using the governing equations from the book for DC motors
Transfer functions and control loops were Implemented to model using Simulink blocks.
Joints
Independent
controller
Coordinate Transformation
Selecting Gain Values Selection was done by testing the system with different signals
and then optimizing the response and Stability of the model. The selected gain values for the controller1 & 2 are:
The Gain values and controller response was measured carefully using scope
Driving the End-Effector from Point to Point
Solver for dynamic Equation
ODE-solver(Dormand price) with variable step was used for forward dynamics.
This solver follows Netwon –Euler formations for calculating forces and torques that we studied in the class.
These toques and forces can be monitored using a torque/force sensor that can be applied to joint.
Simulation results: Video 1 tells you response of uncontrolled system. We can easily
see the DOF being violently dominating on the overall structure. Video 2 is the controlled from of the constraints Video 3 is pick and place. Video 4 is controlled from controller and constraints. The behavior of the last video is thought to be because the mass
of the end-effector was heavy and the corresponding Inertia Matrices were giving High values.
Changing the Creo design and simulating again is the solution.
Conclusion
Equation and Models studied in the class i.e. forward kinematics, transfer functions and dynamic equations were applied on the model and real time application/working was seen.
This project increased by prospective and skills in the field of robotics.
Thank You