Project At a Glance - COP24 JAPAN PAVILIONcopjapan.env.go.jp/cop/cop24/assets/pdfs/events/... ·...
Transcript of Project At a Glance - COP24 JAPAN PAVILIONcopjapan.env.go.jp/cop/cop24/assets/pdfs/events/... ·...
Project At a Glance
Project DescriptionA large-scale CCS demonstration project is being conducted by Japan CCS Co., Ltd (JCCS) inTomakomai City, Hokkaido Prefecture, Japan under commissioning by the New Energy and IndustrialTechnology Development Organization (NEDO) with subsidies from the Ministry of Economy, Tradeand Industry (METI). The objective is to demonstrate the viability of a full-chain CCS system, from CO2
capture to injection and storage. Approximately one hundred thousand tonnes/year of CO2 is beinginjected and stored in offshore reservoirs in the Tomakomai port area. Construction of the facilitieswas completed in October 2015, and after a test-run, CO2 injection commenced in April 2016.
Objective & Tasks Overall Objective: Develop practical CCS technology by around 2020
Tasks:▪ Demonstrate full-chain CCS system from capture to storage▪ Confirm existing technologies adopted in the system work properly and efficiently▪ Demonstrate CCS system is safe and reliable▪ Remove concerns about earthquakes by the data collected;
- no influence by natural earthquakes on CO2 stored. - no perceptible earth tremors induced by CO2 injection
▪ Disclose project information & data and enhance understanding of CCS by general public▪ Clearly define areas to be improved or solved toward commercialization
Schedule
1
Main CCS Parameters/Flow Scheme
FY: from April of calendar year to following March
Tomakomai City, Hokkaido, Japan
Tokyo
Selection of Tomakomai Area
Tomakomai was selected from among 115 candidate sites as a result of comprehensiveinvestigations and site surveys (FY2008~FY2011), and was authorized by the Evaluation Committeeorganized by METI. The data collected by detailed site surveys were used to establish a geologicalmodel and to perform simulation of long-term CO2 behavior prediction. The results obtainedrevealed that the geological structures and formations in the Tomakomai area were highly suitablefor geological CO2 storage.
Construction Phase
During the construction phase (FY2012 – FY2015), the following work was conducted
Construction of onshore facilities Design, construction and commissioning of facilities necessary for capture and injection
of CO2
Drilling of injection wells Drilling of two wells for injecting CO2 into deep subsea reservoirs
Baseline monitoring Development of monitoring network for obtaining baseline data
Studies of regulations and standards for safety Review of laws and regulations, technical standards and guidelines related to CCS
Progress to Date & Demonstration Schedule
Demonstration Operation Phase
The Demonstration Operation phase (FY2016 – FY2020) constitutes the following:
CO2 Separation/Injection Test injection has been completed, and full injection will be conducted until FY2018.
Monitoring Monitoring of CO2 behavior, natural earthquakes, micro-seismicity by observation wells,
seismometers, and 2D/3D seismic surveys will be carried out during CO2 injection, andfor 2 years after termination of injection.
Marine environmental surveys will be carried out seasonally (4 times per year), eachyear between FY2016 and FY2020.
2
Main Features of Tomakomai Project
▪ First full-chain CCS system deployed in Japan
▪ Low energy CO2 capture process→ Page 4
▪ First case of deviated CO2 injection wells drilled from onshore to
offshore→ Page 5, 6
▪ Lower drilling & maintenance costs
▪ Injection interval of over 1km enhances injection efficiency
▪ Extensive monitoring system→ Page 7
▪ Confirm safety and stability of CCS system
▪ Remove concerns about earthquakes
▪ CO2 storage governed by Act on Prevention of Marine Pollution
& Maritime Disaster (Japanese law reflecting London Protocol)→ Page 8
▪ First case of CCS near urban area; extensive public outreach
activities engaging local government, residents and industry
→ Page 9
Bird’s eye view of Onshore Facilities
3
CO2 Capture
Two-stage Absorption System with Low-pressure Flash Tower
▪ Depressurization in Low Pressure Flash Tower strips substantial portion of CO2
▪ Energy consumption is significantly smaller than conventional CO2 capture
process
The CO2 source is a hydrogen production unit of an adjacent oil refinery, which supplies off gascontaining approximately 50% CO2 from a Pressure Swing Adsorption (PSA) hydrogen purification unit.In the capture facility, gaseous CO2 of 99% purity or higher is recovered by a commercially provenamine scrubbing process. A two-stage absorption system including low pressure flash tower reducesthe amine reboiler duty in the capture system, and the energy consumption for CO2 capture issignificantly smaller than that of a conventional CO2 capture process.
CO2 Stripping Tower
CO2 Absorption Tower
Low-pressure
Flash Tower
Tomakomai CO2 Capture Process
4
Two-stage CO2
Absorption Tower
CO2 Stripping Tower
Low-pressure Flash Tower
CO2 Injection
▪ Deviated CO2 injection wells drilled into
offshore reservoirs from an onshore site Cost reduction of drilling, operation and
maintenance
▪ Injection interval length exceeding 1km
to enhance injection efficiency
At the onshore injection facility, the CO2 is compressed and injected into two different offshorereservoirs by two separate deviated wells. The storage points are located 3 to 4km offshore. Theshallow reservoir (Moebetsu Formation), a saline aquifer mainly composed of sandstone locatedapproximately 1,000m~1,200m below the seabed, was reached by an extended reach drilling(ERD) well with a maximum inclination of 83 degrees, vertical depth of 1,188m and horizontal reachof 3,058m. The deep reservoir (Takinoue Formation) is a saline aquifer composed ofvolcanic/volcaniclastic rocks located approximately 2,400m~3,000m below the seabed. The deepinjection well has a maximum inclination of 72 degrees, vertical depth of 2,753m and horizontalreach of 4,346m. The injection intervals for both wells are over 1km in length in order to enhanceinjection efficiency.
Schematic Geological Section
Injection from Onshore to Offshore
5
Compressor Heads of injection wells
Injection Well for Moebetsu Formation
Wellbore Schematic Diagrams
Injection Well for Takinoue Formation
6
7
Objectives of Monitoring and Verification
Confirm the safety and stability of CO2 injection The CO2 behavior in the reservoirs will be monitored continuously to detect any CO2
leakage.
Seismic surveys to delineate the subsurface CO2 distribution, and monitoring of theinjected CO2 volume, formation pressure and temperature will be conducted.
Baseline seismic surveys were conducted during the site survey and preparationphases, and 2D and 3D seismic surveys will be repeated yearly until the end of theproject.
The monitoring data will be used to update a simulation model to predict CO2
behavior.
Verify that natural earthquakes do not affect the stored CO2, and that CO2
injection does not cause any increase in noticeable tremors Monitoring of natural earthquakes and micro-seismicity will be conducted
Monitor the marine environment Surveys and monitoring will be conducted on ocean currents, water quality, seabed
mud, marine organisms, etc., in accordance with the “Act on Prevention of MarinePollution and Maritime Disaster”.
Monitoring System
An extensive monitoring system comprising 3 observation wells, 4 ocean bottom seismometers, 1ocean bottom cable, wellbore temperature/pressure, and flow meters has been established tocontinuously measure the temperature and pressure of the reservoirs, and to monitor naturalearthquakes and micro-seismicity.
Observation well OB-3 for Takinoue Fm.(vertical)
Observation well OB-2 for Moebetsu Fm.(vertical)
Working area of 3D seismic survey
Onshore Seismometer
Observation well OB-1 for Takinoue Fm. converted from survey well (deviated)
OBS
OBS
OBSOBSOBC
Injection well for Moebetsu Fm.Injection well for Takinoue Fm.
Image: LC8107030201641LGN00, Courtesy of the U.S, Geological Survey, text by JCCS
Monitoring & Verification
Monitoring & Verification
Schematic Diagram of Monitoring System
8
Marine Environmental Monitoring
Subsea CO2 geological storage is regulated by the “Act on Prevention of Marine Pollution andMaritime Disaster”, enforced to reflect the London 1996 Protocol. Marine environmental surveyswere conducted in FY2013 and FY2014; from FY2016, seasonal surveys will be conducted quarterly.
● Environmental Survey Points
Image: LC8107030201641LGN00, Courtesy of the U.S, Geological Survey, text by JCCS
Public Engagement
Panel Exhibitions CCS Forums Site tours & lectures
CCS courses for senior citizens Science classes & site tours for schoolchildren
Tomakomai City
Tomakomai City has a population of 172,000, and as the operation is taking place in the port area,intensive stakeholder engagement is being implemented. In 2011, when the city was still acandidate site, METI, the Tomakomai government and JCCS hosted the first CCS forum inTomakomai City, and shared information about CCS and the potential of this technology with thelocal citizens. A survey conducted in conjunction with the forum found that they were concerneddue to their unfamiliarity with the CCS technology, and requested open disclosure of information,confirmation of safety and reliability, and the dissemination of information to the youngergeneration as a technology for the future. On the basis of the survey result and otherconsiderations, JCCS formulated its plans for public outreach activities, which include panelexhibitions, CCS forums, site tours and lectures, CCS courses for senior citizens, and science classesfor schoolchildren.
Newsletter Published by CCS Promotion AssociationAssociation Meeting
Outreach activities for local communities
9
Tomakomai CCS Promotion Association
Activities:• Promotion of Tomakomai CCS Demonstration Project
• Dissemination of information to Tomakomai citizens
Chairman: Tomakomai City Mayor
Secretariat: Tomakomai City
Members: All major corporations in Tomakomai and industrial associations including
Tomakomai Fishery Cooperative
Outreach Materials
University lectures Environmental exhibitions in Japan
International exhibition & presentations Site visits for international visitors
Pamphlets & Panels School Supplies Comics
Promotion Movies Animation Movie JCCS Website
10
Public Outreach
Other areas in Japan & overseas