Prestige LED component matrix The PRESTIGE SYSTEM … · Prestige LED component matrix Five steps...
1
Prestige LED component matrix Five steps to the right light SB 02 Quick-fix bracket for mounting on solid ceilings. SBT 1502 Quick-fix bracket for mounting on 15 mm T-profile ceilings. SBT 2402 Quick-fix bracket for mounting on 25 mm T-profile ceilings. CHP 02 Suspension chain mounting bracket. CHP 02 + CHS Suspension chain mounting bracket plus 1100 mm long chain. Other chain lengths on request. RS 02 Adjustable 1.5 mm diameter 1100 mm long suspension rope. Other rope lengths on request. RSE 02 Adjustable 1.5 mm diameter 1100 mm long suspension rope with 3-, 5-, or 9-pole cable for mains connection. Other rope lengths on request. SURFACED SUSPENDED OMS spol. s r.o. • Dojč 419 • 906 02 Dojč • Slovakia Tel: +421 34 694 0811• Fax: +421 34 694 0888 • Email: [email protected] www.omslighting.com The PRESTIGE SYSTEM embodies the ultimate in its ability to adapt to the most demanding and complex mix of lighting needs. PRESTIGE LED II – LED-OPTIMISED CONVENTIONAL OPTICS PRESTIGE LED LSK – ADVANCED LENS-ONLY OPTICS MEDIUM WIDE A linear LED luminaire determined for continuous installation. Equipped with an advanced lens-only op- tical system. It has a wide and even light distribution suitable for general illumination, or for use in narrow spaces such as storage or retail aisles where low shelves (up to 5 m) are installed. DEEP A linear LED luminaire determined for continuous installation. Equipped with an advanced lens-only op- tical system. It has a narrow light distribution suitable for general illumination when mounted at higher than average heights, or for use in narrow spaces such as warehouse or supermarket aisles where tall shelves (5–14 m) are installed. TWIN DEEP A linear LED luminaire determined for continuous installation. Equipped with an advanced lens-only opti- cal system. It has a narrow light distribution suitable for high-bay application, or use in other areas with very high installation heights. TRIO DEEP A linear LED luminaire determined for continuous installation. Equipped with an advanced lens-only op- tical system. It has a narrow light distribution suitable for high-bay application, or use in other areas with very high installation heights. ASYM A linear LED luminaire determined for continuous installation. Equipped with an advanced lens-only optical system. It has a right or left oriented asymmet- ric light distribution suitable for use in areas where illumination is needed to one side only and shielded in the opposing direction, such as cabinet displays, blackboards and whiteboards, presentation screens, and wall displays. DOUBLE ASYM A linear LED luminaire determined for continuous installation. Equipped with an advanced lens-only optical system. It has a right and left oriented double asymmetric light distribution suitable for use in areas where illumination is needed to both sides such as warehouse and supermarket aisles. It is specifically designed for the illumination if shelves as the light is predominantly directed onto vertical surfaces, deter- mining it for use where shelved items must be clearly identifiable. PAR-L A linear LED luminaire determined for continuous installation. Equipped with a polished Alanod alu- minium reflector and polished aluminium parabolic louvre optical system. It has a wide and even light distribution suitable for general illumination. Fulfils UGR <19 parameters for office lighting. MEDIUM WIDE A linear LED luminaire determined for continuous installation. Equipped with a polished Alanod alumin- ium reflector optical system. It has a wide and even light distribution suitable for general illumination, or for use in narrow spaces such as storage or retail aisles where low shelves (up to 5 m) are installed. DEEP A linear LED luminaire determined for continuous installation. Equipped with a polished Alanod alu- minium reflector optical system. It has a narrow light distribution suitable for general illumination when mounted at higher than average heights, or for use in narrow spaces such as warehouse or supermarket aisles where tall shelves (5–14 m) are installed. ULTRA DEEP A linear LED luminaire determined for continuous installation. Equipped with a polished Alanod alumin- ium reflector optical system. It has a very narrow light distribution suitable for general illumination when mounted at higher than average heights, or for use in narrow spaces such as warehouse or supermarket aisles where tall shelves (5–14 m) are installed. ASYM A linear LED luminaire determined for continuous installation. Equipped with a polished Alanod aluminium reflector optical system. It has a right or left oriented asymmetric light distribution suitable for use in areas where illumination is needed to one side only and shielded in the opposing direction, such as cabinet displays, blackboards and whiteboards, presentation screens, and wall displays. DOUBLE ASYM A linear LED luminaire determined for continuous in- stallation. Equipped with a polished Alanod aluminium reflector optical system. It has a right and left oriented double asymmetric light distribution suitable for use in areas where illumination is needed to both sides such as warehouse and supermarket aisles. It is specifically designed for the illumination if shelves as the light is predominantly directed onto vertical surfaces, deter- mining it for use where shelved items must be clearly identifiable. STEP 5 Additional features AIR ECO A spotlight with CRI +80 and lumen outputs of 1450 lm at CCT 3000 K or 1550 lm at CCT 4000 K. It offers great op- tical versatility thanks to a facet anodised aluminium 24º or 40º reflector and optional coloured filters. AIR II A more powerful option with lumen outputs from 1300 lm to 2700 lm, CCTs of 3000 K and 4000 K, and CRI +80. Equipped with a facet anodised aluminium 24º or 40º reflector and optional coloured filters. ZIPAR TRACK Small, powerful, and fully dimmable with lumen outputs from 1100 lm to 2700 lm, CCTs of 3000 K or 4000 K, and CRI 80+. Equipped with a facet anodised aluminium 8º, 24º, or 40º reflector. AVIOR TRACK Versatile dimmable spot- light with toollessly ex- changeable facet anodised aluminium 24º, 40º, and 60º reflectors and optional coloured filters. Available with lumen outputs from 1300 lm to 4300 lm, CCTs of 3000 K and 4000 K, and CRI 80+. SPOTLIGHTS In many types of space, it is benefi- cial to use accent lighting to effec- tively draw attention to the right places. The PRESTIGE SYSTEM ena- bles the addition of track spotlight luminaires directly on the same mounting rail as the PRESTIGE lu- minaires. This provides the perfect combination of practical and at- tention grabbing lighting without complication. TORNADO II ECO LED With IP65 and IK09, opal diffuser optical system, and a medium wide light distribution. Available with lumen outputs from 1750 lm to 3550 lm. It has an optimal efficacy of 109 lm/W, CRI 80+, and CCTs of 3000 K and 4000 K. TORNADO II LED With IP65 and IK09. Available in M and L, with a reflector and opal dif- fuser optical system, and a wide light distribution. With lumen outputs from 2950 lm to 5800 lm, CCTs of 3000 K or 4000 K, and CRI 80+. It offers an optimal efficacy of 114 lm/W ORIA With IP65 and IK08, prismatic polycarbonate diffuser optical system, a medium wide light distribution, lumen outputs from 3600 lm to 8800 lm, CTTs of 3000 K, 4000 K, or 5000 K, and CRI 80+. It has an optimal efficacy of 140 lm/W. LUMINAIRE ALTERNATIVES Despite the great technical, func- tional, and optical flexibility of PRESTIGE LED, there are times when other luminaires are more suitable. The PRESTIGE SYSTEM now offers the option to use the same mounting rails and electrical infrastructure with the advantages of the luminaire you want. Mounting rails are available in single-, double-, and triple-lumininaire lengths to be selected according to spatial and configuration requirements. All are pre-wired during manufacture with 5-, 7-, or 9-pole 1.5 mm 2 or 2.5 mm 2 cross section cabling equipped with axial connectors that enable fast, toolless connection of multiples rails. Luminaires can be equipped with FIX or DALI drivers and 3H emergency units. STEP 2 Wiring STEP 1 Mounting LED LSK MOUNTING RAIL MR LED II Mounting rails (MR) are made of 0.6 mm calendared sheet steel with a white polyester resin painted surface finish. They can be mechan- ically and electrically connected using zinc-coated sheet steel con- nectors, and finished with covers and end pieces as needed. CONNECTORS MRCP 02 Standard connector. MT T II T-shaped connector. MR L II L-shaped corner connector. MR L/T/X01/X02 Cross-shaped connector supplied with plastic cover and end pieces. FINISHING PIECES ACCESSORIES SOCKET Cover with built-in electrical outlet for con- nection to the mounting rail wiring. SENSOR Cover with built-in sensor (type according to customer request). TRACK DEVICE MOUNT Cover with integrated GLOBAL Trac system. Used to mechanically and electrically mount track devices on the PRESTIGE mounting rail. MRE Self-extinguishing ABS plastic end piece. Used to conceal open mounting rail ends. Order separately. MR COVER Sheet steel cover with white polyester resin paint surface finish. Used to conceal open mount- ing rail sections. Order separately. MR PLASTIC COVER Self-extinguishing ABS plastic cover. Used to conceal open mounting rail sections. Order separately. STEP 3 Configuration STEP 4 Optics / LED LSK STEP 4 Optics / LED II 5-POLE Suitable for three phase operation, or two phase operation plus control line or emergency lighting. 7-POLE Suitable for three phase operation plus LMS or emergency lighting, or two phase operation plus LMS and emergency ligthing. 9-POLE Suitable for three phase operation plus LMS and emergency lighting, or two phase operation plus LMS, emergency lighting, and loud speaker system or other separated phase circuit.
Transcript of Prestige LED component matrix The PRESTIGE SYSTEM … · Prestige LED component matrix Five steps...
-
Prestige LED component matrix Five steps to the right light
SB 02Quick-fix bracket for mounting on solid ceilings.
SBT 1502Quick-fix bracket for mounting on 15 mm T-profile ceilings.
SBT 2402Quick-fix bracket for mounting on 25 mm T-profile ceilings.
CHP 02Suspension chain mounting bracket.
CHP 02 + CHSSuspension chain mounting bracket plus 1100 mm long chain. Other chain lengths on request.
RS 02Adjustable 1.5 mm diameter 1100 mm long suspension rope. Other rope lengths on request.
RSE 02Adjustable 1.5 mm diameter 1100 mm long suspension rope with 3-, 5-, or 9-pole cable for mains connection. Other rope lengths on request.
SURFACED SUSPENDED
OMS spol. s r.o. • Dojč 419 • 906 02 Dojč • Slovakia Tel: +421 34 694 0811• Fax: +421 34 694 0888 • Email: [email protected]
www.omslighting.com
The PRESTIGE SYSTEM embodies the ultimate in its ability to adapt to the most demanding and complex mix of lighting needs.
PRESTIGE LED II – LED-OPTIMISED CONVENTIONAL OPTICS
PRESTIGE LED LSK – ADVANCED LENS-ONLY OPTICS
MEDIUM WIDEA linear LED luminaire determined for continuous installation. Equipped with an advanced lens-only op-tical system. It has a wide and even light distribution suitable for general illumination, or for use in narrow spaces such as storage or retail aisles where low shelves (up to 5 m) are installed.
DEEPA linear LED luminaire determined for continuous installation. Equipped with an advanced lens-only op-tical system. It has a narrow light distribution suitable for general illumination when mounted at higher than average heights, or for use in narrow spaces such as warehouse or supermarket aisles where tall shelves (5–14 m) are installed.
TWIN DEEPA linear LED luminaire determined for continuous installation. Equipped with an advanced lens-only opti-cal system. It has a narrow light distribution suitable for high-bay application, or use in other areas with very high installation heights.
TRIO DEEPA linear LED luminaire determined for continuous installation. Equipped with an advanced lens-only op-tical system. It has a narrow light distribution suitable for high-bay application, or use in other areas with very high installation heights.
ASYMA linear LED luminaire determined for continuous installation. Equipped with an advanced lens-only optical system. It has a right or left oriented asymmet-ric light distribution suitable for use in areas where illumination is needed to one side only and shielded in the opposing direction, such as cabinet displays, blackboards and whiteboards, presentation screens, and wall displays.
DOUBLE ASYMA linear LED luminaire determined for continuous installation. Equipped with an advanced lens-only optical system. It has a right and left oriented double asymmetric light distribution suitable for use in areas where illumination is needed to both sides such as warehouse and supermarket aisles. It is specifically designed for the illumination if shelves as the light is predominantly directed onto vertical surfaces, deter-mining it for use where shelved items must be clearly identifiable.
PAR-LA linear LED luminaire determined for continuous installation. Equipped with a polished Alanod alu-minium reflector and polished aluminium parabolic louvre optical system. It has a wide and even light distribution suitable for general illumination. Fulfils UGR
