The 4 main parts of the guitar

The body The neck

The headstock The fret board

Band saw

Belt sander

Router

Fretting tools

Chisel set

Drill press

Clamps

Materials

2”x16” hardwood board

2”x6” hardwood board template

Guitar hardwareWood glue Wood for the fret board

Take the body board and trace the template on it.

Use the band saw and cut the board around where you traced.

Use the belt sander around the edges to sand off any cut marks.

Trace the holes from the template on the front and back of the guitar.

Use the router and cut the holes in the top and bottom of the guitar.

Trace the guitar neck on the neck board.

Cut it out with the band saw.

Use the chisel set to round the back of the neck.

Drill the holes for the tuning pegs.

Trace the template of the fret board on the wood for the fret board.

Cut it out with the band saw.

Clamp the fret board to the neck and wait until dried.

Use the fretting tools to cut the slots for the frets. Then install the frets.

Screw the neck into the body.

Install all the body hardware and neck hardware.