presentation on mould
-
Upload
badal-panchal -
Category
Education
-
view
3.388 -
download
3
description
Transcript of presentation on mould
INTRODUCTION
BADAL.S.PANCHALY850013
V TH SEMESTER TRAINING PRESENTATION
COMPANY:-ABHIJEET DIES AND TOOLS PVT.LTD.
(KANDIVALI)
Introduction of company
• The company Came into existence in 1984 with a purpose of manufacturing high quality plastic injection moulds. The have been manufacture plastic injection mould up to 1300-ton capacity. Moulded parts are supplied to various Automobiles, household and home- appliance industries
DIFFERENT PARTS OF MOULD
• A mould is basically a component that contains two different assembled parts. These are punch assembly and cavity assembly.
• In Injection Moulding MachineThe Cavity is fixed to the fixed platen of the machine
• The core is fixed to the moving platen of the machine
The material used in the mould
• P-20 :-used for core and cavity• EN-36:-used for guide pin,guide
bush etc• OHNS:-used for inserts, finger pin
etc• MS:-used for locating ring, cam
rod.• COPPER:-used for electrode
CAVITY ASSEMBLY
• Locating ring provides proper alignment to the nozzle and sprue bush
• Sprue bush is the channel between the nozzle and runner
• This cavity plate contains runner which carries the material and gate which is restriction in the runner
Runners and gates
Core assembly
• Ejector plate assembly contains • ejector plate and ejector back
plate• ejector guide pin and ejector guide
bush• Inserts
MOLD INSERTS
• MOLD INSERTS • The punch and cavity are actually
inserts which are inserted in metal block .
• This causes it to be economical and the insert can be changed when damaged .
• Generally the inserts are made of hard material and the block made of cheaper material . Also hardening can be easily done of insert .
• The Bolster plates are housing for these inserts.
venting
• Venting is necessary because While injecting the melt, the air from the mould is required to be escape
DRAFT ANGLE
• The purpose of draft is to first provide release from the core side of the mold
BOLTING
• There is different size of bolts used in a mould to assemble different parts. The bolts used in most application in a mould are Allen bolts.