Preparation · Preparation ① Prepare pH standard solutions ② Connect the electrode to the meter...
Transcript of Preparation · Preparation ① Prepare pH standard solutions ② Connect the electrode to the meter...
Remove the protective cap.Open the internal solution �ller port.
Preparation① Prepare pH standard solutions
② Connect the electrode to the meter
③ Press the power key of the meter
pH9pH9pH4pH4
pH7
pH7
MEASCAL DATA
LIGHT
SETMODE
ENT
※Illustration is image of D-72
④ Remove the protective cap from the electrode, and open the internal solution �ller port
Temperature connector
Press
CODE:GZ0000336672AJanuary, 2017 © 2017 HORIBA Advanced Techno Co., Ltd.
Quick Manual Portable pH Meter D-71/D-72
MEASCAL DATA
LIGHT
SETMODE
ENT
http://www.horiba-water.com
Electrode connector
Press
MEASCAL DATA
LIGHT
SETMODE
ENT④ Start the third point calibration
Immerse the electrode in the pH 7 standard solution until the liquid junction is fully submerged.
Immerse the electrode in the pH 4 standard solution until the liquid junction is fully submerged.
To measurement or second point calibration
To measurement or third point calibration
② Start the �rst point calibration
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
SETMODE
MEASCAL DATA
LIGHT
SETMODE
ENT
② Start the measurement
③ Start the second point calibrationMEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
① Enter the calibration mode
Immerse 3 cmor more.
Immerse 3 cmor more.
Immerse 3 cmor more.
① Enter the measurement mode
When the measurement sample is known to be acidic, perform two-point calibration with pH 7 and pH 4. When it is known to be alkaline, perform two-point calibration with pH 7 and pH 9. When the sample pH is not known, perform three-point calibration with pH 4, pH 7 and pH 9. Calibration
To measurement
Immerse the electrode in the pH 9 standard solution until the liquid junction is fully submerged. ※The calibration method is the same as first and second point calibration.
Measurement
Con�rm that the instantaneous value is stable, then press .
Con�rm that the instantaneous value is stable, then press .
When changes from the blinking state tothe lit state and appears, calibration is complete.
When changesfrom the blinking stateto the lit state and appears, calibration iscomplete.
When changesfrom the blinking stateto the lit state and appears, calibration iscomplete.
When performing the second point calibration,press .
When performing the third point calibration,press .
Press
Press
When changes from the blinking stateto the lit state, measurement is complete.
When the batteries run out or the meter will not be used for a long period, remove the batteries.
NOTE