PP21052a
2
Auto Techs Security Systems Website: www.AutoTechs.com E-mail: [email protected] Address: 3732 Grissom Ln. Kissimmee, Florida, 34741 407-870-8816 Following instructions are only for your remote, make sure you are doing those steps precisely, if you have any questions, please call 407-870-8816 for free tech support. Auto Tech Security Systems shall not be held responsible for any type of damage, intentional or otherwise, caused by the use of the programming instructions and guidance. Auto Tech Security Systems is not responsible for any type of harm, whether physical or otherwise, due to correct or incorrect use of procedures or techniques provided for transmitter programming. No liabilities for any use of the programming instructions and/or telephone guidance are assumed whatsoever for any cost, claims or damages filed for or caused by correct or incorrect use of the information provided for programming. ©2006 AutoTech Security Systems Programming Procedure #21052A Infrared remote control - 1994-95 ***** A maximum of 4 remotes can be programmed 1. Reprogram all remotes. 2. Switch ignition on. ***** Use key that is not fitted with remote control. 3. Manually lock vehicle using remote. 4. Complete the following within 30 seconds, one remote at a time. 5. Point remote to be programmed at receiver. Located in 'B' pillar on both sides. 6. Within 5 seconds press lock/unlock button on each remote 1-4 times at intervals of at least 1 second. a) Once for memory position 1 (first remote). b) Twice for memory position 2 (second remote). c) Three times for memory position 3 (third remote). d) Four times for memory position 4 (fourth remote). 7. Alarm horn sounds each time button is pressed, to indicate signal received. 8. After programming last remote, wait 10 seconds. 9. Press lock/unlock button once to confirm programming. 10. Vehicle unlocks. Programming mode deactivated.
-
Upload
jose-alvarez -
Category
Documents
-
view
212 -
download
0
description
PDF
Transcript of PP21052a
-
Auto Techs Security Systems
Website: www.AutoTechs.com E-mail: [email protected]
Address: 3732 Grissom Ln. Kissimmee, Florida, 34741
407-870-8816
Following instructions are only for your remote, make sure you are doing those steps precisely, if you have any questions,
please call 407-870-8816 for free tech support.
Auto Tech Security Systems shall not be held responsible for any type of damage, intentional or otherwise, caused by the use of the programming instructions and guidance. Auto Tech Security Systems is not responsible for any type of harm, whether physical or otherwise, due to correct or incorrect use of procedures or techniques provided for transmitter programming. No liabilities for any use of the programming instructions and/or telephone guidance are assumed whatsoever for any cost, claims or damages filed for or caused by correct or incorrect use of the information provided for programming.
2006 AutoTech Security Systems
Programming Procedure #21052A
Infrared remote control - 1994-95
***** A maximum of 4 remotes can be programmed
1. Reprogram all remotes.
2. Switch ignition on. ***** Use key that is not fitted with remote control.
3. Manually lock vehicle using remote.
4. Complete the following within 30 seconds, one remote at a time.
5. Point remote to be programmed at receiver. Located in 'B' pillar on both sides.
6. Within 5 seconds press lock/unlock button on each remote 1-4 times at intervals of at least 1 second. a) Once for memory position 1 (first remote). b) Twice for memory position 2 (second remote). c) Three times for memory position 3 (third remote). d) Four times for memory position 4 (fourth remote).
7. Alarm horn sounds each time button is pressed, to indicate signal received.
8. After programming last remote, wait 10 seconds.
9. Press lock/unlock button once to confirm programming.
10. Vehicle unlocks. Programming mode deactivated.
