Pot Noodle Holder Measurement Sheet Fusion 360 Tutorial · Pot Noodle Holder -Measurement Sheet...
Transcript of Pot Noodle Holder Measurement Sheet Fusion 360 Tutorial · Pot Noodle Holder -Measurement Sheet...
Page 1 [email protected]
Pot Noodle Holder - Measurement Sheet
Fusion 360 Tutorial
Use this handout to help you calculate and record the dimensions of your pot noodle holder. Don’t forget
to use the callipers to help you get really accurate measurements.
You will make a side profile sketch similar to this
in Fusion 360 which will then be revolved 360°
in order to make the pot noodle holder. To
create this sketch the following dimensions must
be considered:
(1) Radius of the base
(2) Height of holder
(3) Radius of the top rim
(4) Length and position of grip indents
(1) Radius of the Base
(2) Height of Holder
B. The gab between the edge of
the pot and the holder needs to
2.5mm all the way round.
A. The thickness of the holder
needs to be 5mm to insulate your
hand from the hot pot noodle.
C. Diameter of the pot noodle
base = _________mm
Calculate what the total
diameter of the base of the
holder needs to be:
____+____+____+____+____ =
________ mm
Therefore what should the base
radius of the holder be?
________ mm
D. Decide how high up the pot
noodle you want your holder to
reach.
Mark it with a pen and measure
the height from the base to your
mark.
What is the height of your holder?
Remember to add the depth of the
base of the holder.
_____ +_____ = _______ mm
Page 2 [email protected]
(3) Radius of the Top Rim
F. The gap between the edge of
the pot and the holder is the same
as B.
E. The thickness of the holder
wall is the same as A.
G. Measure the diameter of the
pot noodle at your marker you
made: _________ mm
Calculate what the total
diameter of the top rim of the
holder needs to be:
____+____+____+____+____ =
________ mm
Therefore what should the top
rim radius of the holder be?
________ mm
(4) Length and Position of Grip Indents
Use the diagram below to write all your measurements on in order to help you with your CAD drawing
H. You could add two indents to help you grip the holder
better.
How far from the top of your holder will you have your first
indent?
How long will you have your indents? Consider the thickness
of your fingers.
Also think about what the distance between two indents will
be?
_______mm
_______mm
_______mm
Length of indents:
Distance from rim to first
indent:
Distance between
indents:
Radius of the top rim:
Radius of the base:
Height of holder:
_______mm
_______mm _______mm
_______mm _______mm
_______mm