Post Process & Plot Inbuilding Data on Floor Plan Using ... Inbuilding Table on Floor Plan.pdfPage 1...

of 15

Post Process & Plot Inbuilding Data on Floor Plan Using MapInfo:

This information based on MapInfo Professional Version 11.0 (there is a slight difference for other versions)

From iMeasure session folder open (*_FloorPlan.TAB) file

This will open the floor plan in map info as seen below

of 15

1- Open your session

3- Select “Comma delimited CSV (*.CSV)”

4- Select “Current Mapper”

2- Select (*.CSV) session file

5- Click open

of 15

6- Check this box

7- Click ok

of 15

8- Click ok

Click ok if this message appears, if not, than go to the next step

of 15

9- Select the table tab

10- Select Create Points

of 15

11- Select your table if there is multiple open

12- Click “Projection”

13- Select “None Earth”

14- Select “None Earth (feet)”

15- Click ok

of 15

16- Enter at “Max X: 2000”

17- Enter at “Max Y: 2000”

18- Click ok

of 15

19- Make sure is X selected

20- Make sure is Y selected

21- Click Ok

of 15

22- From the layers click add or “+”

23- Select the table (select the correct table you need to plotted) usually is last one

24- Click Ok

of 15

That’s what you will see

of 15

To create thematic

25- From Map tap

26- Select “Create Thematic Map”

of 15

27- Select your template Thematic

28- Click Next

of 15

29- Select the table

30- Select the element (RSCP, EcIo,….) you need to plotted ==

31- Click Next

of 15

32- Click Ok

of 15

Here you will see your plot

Post Process & Plot Inbuilding Data on Floor Plan Using ... Inbuilding Table on Floor Plan.pdfPage 1...

Documents

Transcript of Post Process & Plot Inbuilding Data on Floor Plan Using ... Inbuilding Table on Floor Plan.pdfPage 1...