Planometric Views (room corner). GC Credit Paper – 2002 – Question 3 An Elevation and Plan of a...
-
Upload
simon-hoover -
Category
Documents
-
view
214 -
download
0
Transcript of Planometric Views (room corner). GC Credit Paper – 2002 – Question 3 An Elevation and Plan of a...
Planometric Views (room corner)
Department Department
of of
TechnologicTechnological al
EducationEducation
Gra
phic
G
raphic
C
om
munic
ati
on
Com
mu
nic
ati
on
GC Credit Paper – 2002 – Question 3
An Elevation and Plan of a room layout are shown.
Using the given sizes and start position, draw a Planometric view of the room layout (include the back wall, side wall and the floor area)
Do not show hidden detail
(DA10)
Department of Technological EducationDepartment of Technological Education
GC Credit Paper – 2002 – Question 3
Start by drawing the Plan at the correct angle.
In this case the start point is given at ceiling level so it is necessary to find out where the floor area starts.
Department of Technological EducationDepartment of Technological Education
Draw the positions of any furniture etc. on the floor area.
GC Credit Paper – 2002 – Question 3
Draw the positions of any walls required.
Department of Technological EducationDepartment of Technological Education
Include any doors and windows on the walls.
GC Credit Paper – 2002 – Question 3
Add any furniture to the Planometric view.
Department of Technological EducationDepartment of Technological Education
GC Credit Paper – 2002 – Question 3
Add any furniture to the Planometric view.
Department of Technological EducationDepartment of Technological Education
GC Credit Paper – 2002 – Question 3
To finish the drawing darken the outlines on the drawing.
Remember that the question asks that hidden edges are not shown so some of the lines will be left as construction lines.
Department of Technological EducationDepartment of Technological Education
GC Credit Paper – 2002 – Question 3This drawing was awarded 10 Drawing Ability marks.
The following slides show the official marking scheme for this drawing.
Department of Technological EducationDepartment of Technological Education
Department of Technological EducationDepartment of Technological Education
Draw 2 walls and a floor2 marksIf walls only drawn then 1 mark
GC Credit Paper – 2002 – Question 3The Marking Scheme – box a
Department of Technological EducationDepartment of Technological Education
Draw door (size and position)2 marks
GC Credit Paper – 2002 – Question 3The Marking Scheme – box b
Department of Technological EducationDepartment of Technological Education
Draw picture (size and position)1 mark
GC Credit Paper – 2002 – Question 3The Marking Scheme – box c
Department of Technological EducationDepartment of Technological Education
Draw bookcase (size and position)2 marks
GC Credit Paper – 2002 – Question 3The Marking Scheme – box d
Department of Technological EducationDepartment of Technological Education
Draw sofa (size and position)2 marks
GC Credit Paper – 2002 – Question 3The Marking Scheme – box e
Department of Technological EducationDepartment of Technological Education
Draw carpet (size and position)1 mark
GC Credit Paper – 2002 – Question 3The Marking Scheme – box f