PHY 231 1 PHYSICS 231 Lecture 30: Convection, Radiation & Thermodynamics Remco Zegers Question...
-
Upload
conrad-mason -
Category
Documents
-
view
217 -
download
1
Transcript of PHY 231 1 PHYSICS 231 Lecture 30: Convection, Radiation & Thermodynamics Remco Zegers Question...
PHY 2311
PHYSICS 231Lecture 30: Convection, Radiation &
Thermodynamics
Remco ZegersQuestion hours: Thursday 12:00-13:00 & 17:15-
18:15Helproom
PHY 2312
Convection
T high low
PHY 2313
Radiation
Nearly all objects emit energy through radiation:
P=AeT4 : Stefan’s law (J/s)=5.6696x10-8 W/m2K4
A: surface areae: object dependent constant emissivity (0-1)T: temperature (K)
P: energy radiated per second.
If an object is at Temperature T and its surroundingsare at T0, then the net energy gained/lost is:P=Ae(T-To)4
PHY 2314
emissivity
Ideal reflectore=0no energy is absorbed
Ideal absorber (black body)e=1all energy is absorbedalso ideal radiator!
PHY 2315
A BBQ
The coals in a BBQ cover an area of 0.25m2. If the emissivity of the burning coal is 0.95 and their temperature 5000C, how much energy is radiated everyminute?
PHY 2316
Thermodynamics (chapter 12)
Piston is moved downwardslowly so that the gas remainsin thermal equilibrium:The temperature is the thesame at all times in the gas,but can change as a whole.
vin
voutVout>Vin
Work is done on the gas
PHY 2317
Isobaric compression
Let’s assume that the pressure does notchange while lowering the piston (isobariccompression).
W=-Fy=-PAy (P=F/A)W=-PV=-P(Vf-Vi) (in Joule)
W: work done on the gas+ if V<0- if V>0
This corresponds to the area underthe curve in a P-V diagram
PHY 2318
Non-isobaric compression
In general, the pressure can change whenlowering the piston.
The work done on the gas when goingfrom an initial state (i) to a final state (f) is the area under the P-V diagram.
The work done by the gas is theopposite of the work done on the gas.
PHY 2319
question
v
P
v
P
v
P
In which case is the work done on the gas largest?
A
B C
The area under the curves in cases B and C is largest (I.e. the absolute amount of work is largest). In caseC, the volume becomes larger and the pressure lower(the piston is moved up) so work is done by the gas (workdone on the gas is negative). In case B the work done onthe gas is positive, and thus largest.
PHY 23110
Isovolumetric process
v
P
Work done on/by gas: W=-PV=0
PHY 23111
First Law of Thermodynamics
By performing work on an objectthe internal energy can be changed
By transferring heat to an objectthe internal energy can be changed
The change in internal energy depends on the workdone on the object and the amount of heat transferredto the object.
Remember: the internal energy is the energy associatedwith translational, rotational, vibrational motion of atomsand potential energy
Think about deformation/pressure
Think about heat transfer
PHY 23112
First Law of thermodynamics
U=Uf-Ui=Q+W
U=change in internal energyQ=energy transfer through heat (+ if heat is
transferred to the system)W=energy transfer through work (+ if work is
done on the system)
PHY 23113
First law: examples 1) isobaric process
A gas in a cylinder is kept at 1.0x105 Pa. The cylinder isbrought in contact with a cold reservoir and 500 J of heatis extracted. Meanwhile the piston has sunk and the volumechanged by 100cm3. What is the change in internal energy?
PHY 23114
First Law: examples: 2) Adiabatic process
A piston is pushed down rapidly. Because thetransfer of heat through the walls takes along time, no heat can escape. During the moving of the piston, the temperature has risen 1000C. If the container contained 10 mol of an ideal gas, how much work has been done during the compression?
PHY 23115
First Law: examples 3) general case
V(m3)
P(x105 Pa)
1 4
3
6 In ideal gas is compressed (seeP-V diagram).A) What is the change in internal energyb) What is the work done on the gas?C) How much heat has been transferred to the gas?
i
f
PHY 23116
Types of processes
A: Isovolumetric V=0B: Adiabatic Q=0C: Isothermal T=0D: Isobaric P=0
PV/T=constant
PHY 23117
Metabolism
U=Q+W
Change in internal energy: Must be increased: Food!
Heat transfer: Negativebody temperature < room temperature
Work done (negative)
PHY 23118
Metabolic rate
U = Q + Wt t t
Metabolic rate: rate in which food and oxygen are transformed into internal energy (to balance losses dueto heat loss and work done).
|W/t| Body’s efficiency: |U/t|
PHY 23119
Body’s efficiency
U/t~oxygen use ratecan be measured
W/t can be measured