Philips OneSpace luminous ceiling E-cabinet user manual

2 Philips OneSpace luminous ceiling E-cabinet user manual March 2014

© 2014 Koninklijke Philips N.V.

Philips OneSpace luminous ceiling E-cabinet user manual March 2014 3

Contents

1. Welcome to the world of Philips OneSpace luminous ceiling.................................................4

2. Switching on the E-cabinets .........................................................................................................................5

3. DALI input commands ....................................................................................................................................8

4. Emergency light trigger, E1 only ..................................................................................................................9

5. Manual control E-cabinet ............................................................................................................................10

6. Document information ................................................................................................................................11

4 Philips OneSpace luminous ceiling E-cabinet user manual March 2014

1. Welcome to the world of Philips OneSpace luminous ceiling

OneSpace luminous ceiling is the latest innovation of Philips Large Luminous Surfaces. OneSpace luminous ceiling is a functional white light solution capable of transforming the ceiling of any office, retail or hospitality environment into a clutter-free ceiling.

"The ceiling becomes the light, the light becomes the ceiling."

Key features:• Large illuminated surface, customizable to fit any area• High quality homogeneous light distribution• Glass fiber front and acoustic properties• Highest fire safety class A2, s1-d0

Depending on the configuration, the system can consist of several parts:• A luminous ceiling panel, which is the part that is mounted to the ceiling and generates the light• A group of E-cabinets or E-boxes, which contain the drivers and the electronic control components• A hoisting system, which is used to hoist the panel into final position, and to lower the panel for maintenance

purposes, and can be a permanent hoisting system or a temporary one

For the total luminous ceiling panel system, an installation-, user- and/or service manual is available for the following parts:• Luminous ceiling panel• E-cabinet or E-box• Hoisting system (installation manual only in case of a permanent hoisting system)

About this user manual.This manual contains all the necessary information to use the E-cabinet or E-box for Philips OneSpace luminous ceiling. It describes the start-up sequence and the manual back-up control in case of a malfunction of the building management system. Also information regarding the DALI input and emergency lighting system is given in this user manual.

Philips OneSpace luminous ceiling E-cabinet user manual March 2014 5

2. Switching on the E-cabinets

Before switching on the E-cabinets make sure that all switches and fuses are 'OFF' (due to inrush currents).

50W

N15

*1

50W

N24

50W

N46

10X

012

G2

50W

N16

50W

N38

50W

N47

13N1LPC1

11F

212

F2

50W

N17

50W

N39

14F

2

50W

N18

50W

N40

50W

N19

50W

N41

50W

N20

50W

N42

PE

50W

N21

50W

N43

X1

DA

50W

N22

50W

N44

13N15

50W

N23

50W

N45

15F

214

G2

11K

1250

WN

6150

WN

6950

WN

9015

Q2

14K

18

14N3RS485

15X

250

WN

6250

WN

7050

WN

91

15F

450

WN

6350

WN

8450

WN

9214

G6

15Q

4

14N7RS485

50W

N64

50W

N85

50W

N93

15X

4

15F

650

WN

6550

WN

8650

WN

9414

G10

X2

15Q

6

14N11RS485

50W

N66

50W

N87

15X

6

X3

50W

N67

50W

N88

15F

815

Q8

14G

1450

WN

6850

WN

8915

X8

X4 X8

*1 *1 *1 *1 *1 *1 *1 *1 *1 *1 *1 *1 *1 *1 *1 *1

*1 *1 *1 *1 *1 *1 *1 *1 *1 *1 *1 *1 *1 *1

*1 *1 *1 *1 *1 *1 *1

*1 *1 *1

Switches and fuses15Q2, 15Q4, 15Q6, 15Q815F2, 15F4, 15F6, 15F8

‘OFF’ position

15F2 15Q2

6 Philips OneSpace luminous ceiling E-cabinet user manual March 2014

1. Turn main switch to 'ON' position

OFF

ON

2. Check that surge voltage arrester indicator (2) is lit up (if not, refer to service manual)

3. Make sure that backup switch (3) is in 'NORMAL' position

2 3

Philips OneSpace luminous ceiling E-cabinet user manual March 2014 7

4. Switch 'ON' all fuses and switches, one by one

OFF

ON15F2 15Q2

5. Check if all LEDs are on or flashing (if not, refer to service manual)

8 Philips OneSpace luminous ceiling E-cabinet user manual March 2014

3. DALI input commands

All DALI commands coming from the building management system (BMS) need to comply to DALI standard:

- 1EC62386-101 General requirements - Systems - 1EC62386-102 General requirements - Control Gear

The following broadcast commands will be accepted (when no emergency input is triggered):

- OFF - Min. (10% = value 169) - Max. (100% = value 254) - Direct arc level values between 169 and 254

Ignored values Acceptedvalues

Philips OneSpace luminous ceiling E-cabinet user manual March 2014 9

4. Emergency light trigger, E1 only

The Emergency light mode trigger can be connected in two ways:

• Trigger used as Normally Open contact (NO) - X3-3 and X3-4 shorted

• Trigger used as Normally Closed (NC) - X3-1 and X3-2 leave open

X3 Emergency light mode trigger (E1 only)

trigger used as NO contact input

Short trigger to GND to force emergency light mode

trigger used as NC contact input

Open trigger from GND to force emergency light mode

X3-1Trigger

X3-2GND

E-cabinet E1

X3-3

X3-4

X3-1

X3-2

E-cabinet E1

X3-3

X3-4

Trigger

GND

Emergency light trigger specifications:

• Insulated input circuit• Max 48V DC signal input• < 1V for contact closure• Cabling: low voltage double insulated 2-pole cable, min. 0.5mm2

• Connect according to wiring diagram

N.B. When the emergency light is triggered all other input is ignored

10 Philips OneSpace luminous ceiling E-cabinet user manual March 2014

5. Manual control E-cabinet

All E-cabinets can be separately controlled when switch (1) is turned from position 'NORMAL' to 'BACKUP', using door dimmer (2).

Dimmer functions:

• Switch light - Press the control knob (2)

• Adjust the brightness - Light is switched on - Turn the control knob (2):

left to decrease brightness, right to increase brightness

2

1

Philips OneSpace luminous ceiling E-cabinet user manual March 2014 11

6. Document information

Info Content

Title Philips OneSpace luminous ceiling E-cabinet user manual

Date V1.0 March 2014

Security The attached material and the information contained herein are proprietary to Large Luminous Surfaces, Philips Lighting BV. Copying, reproduction, adaptation, modification or dissemination in whole or part is not permitted without written permission from Large Luminous Surfaces, Philips Lighting.

Contact address

Philips Lighting B.V. Large Luminous Surfaces High Tech Campus 27 5656 AE Eindhoven The Netherlands Website: www.largeluminoussurfaces.com/onespace

12 Philips OneSpace luminous ceiling E-cabinet user manual March 2014

© 2014 Koninklijke Philips N.V.All rights reserved. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner.The information presented in this document does not form part of any quotation or contract, is believed to be accurate andreliable and may be changed without notice. No liability will be accepted by the publisher for any consequence of its use.Publication thereof does not convey nor imply any license under patent- or other industrial or intellectual property rights.

Philips Lighting B.V. Large Luminous SurfacesThe Netherlands