Pharmaceutical wastewater treatment case study
-
Upload
fanny-zhang -
Category
Business
-
view
930 -
download
3
Transcript of Pharmaceutical wastewater treatment case study
Pharmaceutical WastewaterTreatment System---Case Study
About Pharmaceutical Wastewater
There is a microbial fermentation process in the biopharmaceutical unit, producing large amount of organic components after the extraction of useful substances, this chemical residue contains certain acids, bases and organic agents. These materials eventually mix with the clean rinse water, eventually forming a difficult wastewater. Pharmaceutical products take only 5 percent to 15 percent of all feedstock, the remaining form the residual as wastewater or gas.
Practical Case Basic InfoProject name : zero emission water reuse project of a pharmaceutical company in Inner MongoliaCapacity : 6300m³/dFeed water type : pharmaceutical wastewaterEffluent water quality : water quality standard for urban miscellaneous water consumption ( GB18920-2002 )
Feed water type capacity Feed water quality Effluent water quality
pharmaceutical wastewater/ water purification system brine/recycled water discharge/biochemical effluent
Feed water capacity: 6300 m3/d , recovery rate > 92%
Conductivity: 14000μs/cm Conductivity: 500μs/cm
TDS: 8000mg/L TDS: 300mg/LHardness ( CaCO3 ) :580mg/L
Hardness ( CaCO3 ) :200mg/L
Alkalinity:333mg/L Alkalinity: 150mg/LCOD: 260mg/L COD: 50mg/LChloride: 3200 mg/L Chloride: 100 mg/L
One-site Photos ShowIf any questions, please no hesitate to contact us.Visit our website: www.conhoo.com Email: [email protected]
Contact infoWeb: www.conhoo.comEmail: [email protected]: +86 20 3112 9583Fax: +86 20 3112 6793
Thank You