Patrick A. York 1561 Keibler Beach Drive

New Kensington, PA. 15068 724-448-7584

Patrickyork347@yahoo.com

CAREER OBJECTIVE My career objective is to further my career with ATI where my training and skills can be utilized to the benefit of the company. EDUCATION: VALLEY HIGH SCHOOL, New Kensington, PA Graduated, June 1981 INDIANA UNIVERSITY OF PA, Indiana, PA. Curriculum: Business Administration EMPLOYMENT EXPERIENCE ATI Flat Rolled Products- Leechburg, PA 2015 Customer Protection Plan

Job shadowed at #30 Slitter from May to July

Operated #30 Slitter from August to December o Recorded production and delay minutes in Coil Track o Inspected and prepped coils for the rolling mill

Removed and or marked defects according to quality and processing instructions

Changed slitter knives on regular basis o Completed forklift and crane training o Trained temporary work force to safely operate slitter

1995 to Quality Specialist Present

Same responsibilities as Metallurgical Observer position (1991-1995) with added problem solving and leadership accountability described below

o Responsible for reviewing and dispositioning all rejected material from each operation on shift

o Trained crews on quality procedures at each operation o Supervised production and maintenance personnel on off turns o Directed troubleshooting efforts for quality, production and maintenance issues o Conducted housekeeping and employee safety audits o Performed quality audits of material prior to shipment to the customer o Conducted yield study on primary normalizer that resulted in a 1% yield

improvement valued at $500K per year o Team member of 90-day continuous improvement teams that delivered 50 to

85% reduction in quality costs 1994: Strike Duty

Operated overhead cranes and forklifts to services operations

1991 to 1995: Metallurgical Observer

Responsible for ensuring material processed on each operation within speci fications set by Tech Services (SPC charting).

Performed dew point measurements, atmosphere checks, temperature readings, gas flow readings, coating thickness checks, franklin insulation tests, safety gas checks for shutdowns and maintenance

Adjusted gas flows, humidifier settings, C10 paint pump flows to ensure key process variables remain within specification

Trained and assisted crews with production recording issues (Coil Track and IBM). Worked with production to correct any out of spec conditions

1989 to 1991: Magnetic Tester

Responsible for accurately performing all tests required by customers on material produced in Bagdad

UNITED STATES ARMY - Fort Bragg, North Carolina February 1984 to February 1988: Airborne Infantry:

Assigned to machine gun team where I quickly worked my way to position of machine gunner

Achieved rank of E5 in less than three years

Assigned as battalion air items nco my last year of service o Responsible for obtaining all parachutes, weapons cases and hardware needed

for battalion airborne operations o Set up the distribution points at air force base and retrieval points at drop

zones. I was responsible for turning all equipment accounted for o This was accomplished with twenty people assigned to me from the battalion