PAT1000S PORTABLE APPLIANCE TESTER - Seaward · PAT1000S PORTABLE APPLIANCE TESTER OPERATING...
20
PAT1000S PORTABLE APPLIANCE TESTER OPERATING INSTRUCTIONS 203A510 CONTENTS 1) Safety in the use of Electrical Equipment, precautions on testing. 2) Introduction and Description. 3) Application. 4) Operation. 5) Maintenance. 6) Specification. 7) Accessories. Bracken Hill, South West Industrial Estate, Peterlee, Co. Durham SR8 2SW. England. Tel: 0191-586 3511 Fax: 0191-586 0227 www.seaward.co.uk [email protected] [email protected]
Transcript of PAT1000S PORTABLE APPLIANCE TESTER - Seaward · PAT1000S PORTABLE APPLIANCE TESTER OPERATING...
PAT1000SPORTABLE APPLIANCE TESTEROPERATING INSTRUCTIONS
203A510
CONTENTS1) Safety in the use of Electrical Equipment, precautions on testing.2) Introduction and Description.3) Application.4) Operation.5) Maintenance.6) Specification.7) Accessories.
Bracken Hill, South West Industrial Estate,Peterlee, Co. Durham SR8 2SW. England.Tel: 0191-586 3511 Fax: 0191-586 [email protected]@seaward.co.uk
PAT 1000 S cover 154-75 1/4/03 4:07 pm Page 1
NOTICE
Data may be lost or altered in virtually any electronicmemory under certain circumstances. Therefore SeawardElectronic assumes no responsibility for financial losses orclaims due to data lost or otherwise rendered unusablewhether as a result of abuse, improper use, defects, disre-gard of operating instructions or procedures, or any otherallied causes.
The information in this manual is subject to change withoutprior notice.
PAT INTERNAL BATTERY
The Portable Appliance Tester contains an internal rechargeablebattery to maintain the memory when the unit is switched off. Inorder to ensure that this battery maintains operability the follow-ing procedure should be followed:
1. On receipt of the PAT tester, clear the memory and leave theunit switched on for 16 hours.
2. If the PAT will not be in use for weeks at a time the previoustest results should be downloaded onto a printer or computerprior to the unit being stored, otherwise the unit should beswitched on for 16 hours to ensure full charge.
3. If the PAT has not been used for some weeks, the battery canbecome heavily discharged, causing a possible loss of data. Iftest data is still intact it is advisable to download it. When the PATis known to be in a discharged state, power it up to charge thebattery for at least an hour prior to carrying out testing, or leave tocharge for 16 hours.
PAT2000i Cover 01/04/2003 11:43 am Page 1 (Black plate)
1
PAT 1000S Booklet 154-75 7/3/03 3:58 pm Page 1
2
PAT 1000S Booklet 154-75 7/3/03 3:59 pm Page 2
3
PAT 1000S Booklet 154-75 7/3/03 4:00 pm Page 3
4
PAT 1000S Booklet 154-75 7/3/03 4:00 pm Page 4
5
PAT 1000S Booklet 154-75 7/3/03 4:01 pm Page 5
6
PAT 1000S Booklet 154-75 7/3/03 4:02 pm Page 6
7
PAT 1000S Booklet 154-75 7/3/03 4:02 pm Page 7
8
PAT 1000S Booklet 154-75 7/3/03 4:03 pm Page 8
9
PAT 1000S Booklet 154-75 7/3/03 4:04 pm Page 9
10
PAT 1000S Booklet 154-75 7/3/03 4:04 pm Page 10
11
PAT 1000S Booklet 154-75 7/3/03 4:05 pm Page 11
12
PAT 1000S Booklet 154-75 7/3/03 4:06 pm Page 12
13
PAT 1000S Booklet 154-75 7/3/03 4:06 pm Page 13
14
PAT 1000S Booklet 154-75 7/3/03 4:07 pm Page 14
15
PAT 1000S Booklet 154-75 7/3/03 4:08 pm Page 15
16
PAT 1000S Booklet 154-75 7/3/03 4:08 pm Page 16
17
PAT 1000S Booklet 154-75 7/3/03 4:09 pm Page 17
18
PAT 1000S Booklet 154-75 7/3/03 4:10 pm Page 18
