Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

PART DESIGN (DRAWING 02)

From this diagram we have to know,

Selection of plane

Drawing circle

Drawing rectangle

Pad the profile

Pocket definition

Offset plane

Symmetry constraint

Trimming

Object mirror

Chamfer

Fillet

Rotate options

Views

CATIA v5 software is used to modeling this object.

Prepared By

Veerapandian.K Mechanical Engineering.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

WORKING STEPS

Select the suitable plane.

Select line then start draws the half side of the front view.

After completing the sketch select mirror option.

Mirror the drawing sketch.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Pad the completed sketch. Select mirror extent option in pad work.

Then draw rectangle on face. Put symmetry, give dimensions.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Then pocket the rectangle to make path on the job.

Select the face plane. Draw a circle then pad with it suitable dimensions.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

After pad circle, mirror that the circle with suitable reference plane.

Then draw a circle to make hole.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Select the side plane to make hallow path as per given diagram.

Pocket the sketch.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Then select face of body sketch the rectangle with given dimensions.

Pad the rectangle.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Then make tritangent fillet on the rectangle. Then make a hole on the fillet.

Mirror this fillet triangle into all portions as per diagram specification.

Final diagram will be like this.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.