PART #256 - 257 - 258 1957 Horn Cap and Bel Air/210 Emblem ... Sheets/256.pdf · Revised 9/2010...
Transcript of PART #256 - 257 - 258 1957 Horn Cap and Bel Air/210 Emblem ... Sheets/256.pdf · Revised 9/2010...
Revised 9/2010
PART #256 - 257 - 2581957 Horn Cap and Bel Air/210 Emblem
Instruction Sheet
1/1800.854.6911 • WWW.DANCHUK.COM • 3201 S. Standard Avenue, Santa Ana, CA 92705
1. First, remove the center horn cap. This is done by accessing the center cap screws, #10207, through the hole in two steering wheel spoke from the back side.
2. Now to install the #257 - Bel Air, or #258 - 210 emblem into your original or new #256 - horn cap you will need to heat an oven to 200 degrees. Place your horn cap in the oven and wait until it’s hot. Being careful not to burn yourself, insert the new plastic emblem in from the back and bed ing tabs over to lock them in place. A light tap on a small drift punch will be all you need.
3. Now install your new horn cap and emblem back onto the steering wheel.
Note: See diagram below for other items you may need to get the assembly back to new condition.
258 - 210 Emblem
256 - Horn Cap only256A - Horn Cap w/Bel Air Emblem256 - Horn Cap w/210 Emblem
255 - Horn Ring Only
2693 - Washer
10207 Center Cap Screw Kit
15605 Nut
257 - Bel Air Emblem258 - 210 Emblem
257 - Bel Air Emblem256 - 210 /Bel Air Horn Cap