NAMING CONVENTION

Name of panel:-(PROJ. NAME) (BLOCK NAME)-(TYPE) (POSITION)(RUN NO)

Example- AL1BP-DEC01Z1400-A

Explanation:-AL---Project Key.1BP---Block name.DEC01—TypeZ1400---Position.A---Run no (Serial no of panel)

Detailed explanation:-TYPE = TYPE OF PANEL,

TBH = TRANSVERSE BULKHEADLBH = LONGITUDINAL BULKHEADDEC = MAJOR DECK PANELPLT = ANY PLATFORM

GIRXX = GIRDER OF MAJOR DECK,WHERE XX= 01 FOR DECK 1

= 02 FOR DECK 2 = 03 FOR DECK 3 = 04 FOR DECK 4 etc.

BXX = BEAM OF MAJOR DECK, WHERE XX= 01 FOR DECK 1

= 02 FOR DECK 2 = 03 FOR DECK 3 = 04 FOR DECK 4, etc.

FLR = FLOORSFLG = FLANGE

WFR = WEB FRAMESTG = STRINGER

BHK = BREAST HOOK BKT = BRACKET WPL = DEEP WEB,BEAM,FRAME ETC ON ANY PLANE

BPL = BEAM OF PLATFORM GIRPL = GIRDER OF PLATFORM GIRSH = SHELL GIRDER

POSITION = GLOBAL POSITIONFOR X- FR XX [ - AFT OF FRAME] eg. FR30-200X-POSITION IS 200MM AFT OF FR30FOR X- FR XX [-FWD OF FRAME] eg. FR30+200X-POSITION IS 200MM FWD. OF FR30

FOR Y > Y(VALUE), (e.g. Y3000)FOR Z > Z (VALUE), (e.g. Z 3000)FOR INCLINED PLANE > Z3800-4800 IS A PLANE BETWEEN Z=3800 TO Z=4800

[NOTE: X indicates Frames(longitudinal direction), Y indicates Buttock(Transverse direction), Z indicated Water level(Vertical direction) ]

NOTE:PANEL-Panel is made up of number of plates with stiffener, bracket etc. limited to the end of continuity.