OTHER TECHNOLOGIES PV Systems (Solar) Radiant Heat Heat Recovery Units Variable Frequency Drives...
-
date post
22-Dec-2015 -
Category
Documents
-
view
214 -
download
1
Transcript of OTHER TECHNOLOGIES PV Systems (Solar) Radiant Heat Heat Recovery Units Variable Frequency Drives...
OTHER TECHNOLOGIES PV Systems (Solar) Radiant Heat Heat Recovery Units Variable Frequency
Drives
Compact Fluorescent Bulbs
Occupancy Sensors Micro Hydro Drip Irrigation
Solar Resources – Total & Diffuse
Semi-Conductor Physics PV technology uses semi-conductor
materials to convert photon energy to electron energy
Many PV devices employ Silicon (multi-crystalline, amorphous or single) Other electrically active semiconductor materials
Cadmium telluride, gallium asenide, CIS, etc.
Historic PV modules price/cost decline 1958: ~$1,000 / Watt 1970s: ~$100 / Watt 1980s: ~$10 / Watt 1990s: ~$3-6 / Watt 2000-2006:
~$1.8-2.5/ Watt (cost) ~$3.50-4.75/ Watt (price) ~$6.75-8.45/Watt (installed)
PV system types Grid Interactive – and BIPV Stand Alone
Irrigation Pumping / Livestock Watering Troughs Cathodic Protection
Battery Back-Up Stand Alone Refrigeration Communications Rural Electrification Lighting
How Large a System do You Need?
Method: First Determine Electric Use (try to reduce 1st) Determine Solar Resource (SP, model, calcs) Select PV Modules or Select DC-AC Inverter Assure Module Strings Voc and Isc meet inverter
specifications (for max and mins) Estimate Your Production (1200 kWh/ kW-DC)
Grid-interactive roof mounted
NJ Solar (PV) Incentives NJ Clean Energy Program
$3.80/watt rebate for grid connected systems up to 10kW (Smaller rebates above 10kW)
Net Metering to 2MW Solar Renewable Energy Certificates
NJ RPS requires 2 MW 2004 90 MW 2008 27 MW currently installed in the state Currently trading between $110-260/MWh
NJCEP Rebates Solar Electric Systems 2006 (PV
Rebates) * System Size 0 to 10,000 watts $3.80/watt 10,001 to 40,000w $2.75/watt 40,001 to 100,000w $2.50/watt 100,001 to 500,000 $2.25/watt 500,001 to 700,000 $2.00/watt
* - Reduce by ITC if eligible and to 85% of value for self-install
Recent Trades of SRECs ($/MWhr)
Month Max Min Cum Av
Oct 06 $250 $160 $206 Nov 06 $260 $110 $198 Dec 06 $260 $110 $196
Solar PV - Practical Information Approx South Facing Roof or field Roof angles from 20-50 degrees Less than 200’ from loads Every 70 square feet of area can yield up to
1000 kWh per year in New Jersey
Radiant Heat Radiant heat is based on the concept of
circulating hot water through the walls or floor of your greenhouse evenly distributing warmth in a clean, quiet and efficient way.
This type of system is a good alternative given a building that has conventional insulating, large open spaces and tall ceilings, when air flushing is common (i.e. garage) and when population allergy sensitivities are high.
Radiant Heat The system works on the principal of circulating
hot water throughout the area to be heated. The water is pushed through an expansive
network of tubing designed to efficiently tunnel the heat to your living areas.
In this system the heat is concentrated at ground level and filtered up to make for a comfortable climate all around.
Radiant Heat
Radiant Heat Advantages The heat is evenly distributed throughout the
room. Each room can be specifically set to a certain
temperature. This system is also quieter and more efficient with
an average savings of 15-20% than that of forced air.
There is a significant decrease in dry heat which removes the humidity out of the air making radiant heat a more comfortable alternative.
Heat Recovery Units (HRU)
Vapor compression cycle Terribly inefficient (η < 75%) Best known design Energy dissipates as heat
Recover Energy Heat water - Therma-stor™ Heat air - Fantech™
Case Studies Dairy farms use hot water to
clean equipment HRU preheats water which
reduces work done by water heater
Economic Summary
Heating, Venting, and Air Conditioning (HVAC)
Therma-stor™ Fantech™
Power Demand (kWh/yr)
Annual Savings
Installation Cost
Payback
(Years)
No
HRU
16,333 - - -
HRU 5,781 $579 $2,861 5.0
Variable Frequency Drive (VFD)Resolved old problems
Heat Generation Harmonics
Noise Reliability
Common applications Global Electric Market - Pumps (22%), Fans (16%)
Other Benefits Increases equipment’s lifespan
Reduced wear leads to reduced maintenance
Lighting Technologies
Incandescent vs. Compact Fluorescent CFL’s use 2/3 less energy to operate Last 10 times longer than incandescent Save $30 over the lifetime of the bulb Generate 70% less heat
Occupancy Sensors Lighting accounts for
approximately 30 – 50% of a building’s power consumption
By turning off unnecessary lighting could reduce lighting consumption by 45%
Senses movement or lack of movement in a room and consequently turns on or off the lights
Rebates Wall mounted ($20 per
control) Remote mounted ($35 per
control) Daylight dimmers ($25 per
fixture controlled) Occupancy controlled hi-
low fluorescent controls ($25 per fixture controlled)
Micro-Hydro Power Hydropower is based on the principal that
flowing and falling water have kinetic energy.
A water wheel or a turbine turns this energy into mechanical energy and then into electricity by an electric generator.
Micro-hydro systems generate power on the scale of 5 kW to 100 kW.
Micro-Hydro Power Best areas for this system: steep rivers flowing all
year round and areas with high year round rainfall.
Water flow is greater around winter time and photovoltaic systems are at their lowest point of efficiency. Due to this, many micro hydropower systems are complimented with photovoltaic systems to balance out these deficiencies.
Micro-Hydro Typical Setup Intake Weir- Located
upstream to divert flow of water into the channel.
Channel- transports water from intake weir to forebay tank.
Forebay Tank- filters debris and prevents it from being drawn into turbine and penstock pipe.
Penstock Pipe- carries the water from forebay tank to the powerhouse.
Powerhouse- where turbine and generator convert waterpower into electricity.
Theoretical power produced depends on the flow rate of the water, vertical height that the water falls and the acceleration of gravity through the equation:
P = Q * H * c Where P is in units of watts, Q is the flow rate in
m3/sec, H is the vertical height in meters and c is the product of the density of water and gravity in kg/m3 and 9.81 m/s2 respectively.
Micro-Hydro Power
Drip Irrigation A replacement for overhead irrigation, which is
only 40% to 45% efficient Has potential to irrigate at 80% to 95% efficiency May improve upon product quality and crop yield
per acre if designed, operated, and maintained properly
Drip Irrigation Benefits
Reduces water use by application directly to areas of a plant where it is needed most
Water will not have the same opportunity to be blown away or evaporated into the atmosphere as with overhead irrigation
Energy usage and losses due to friction are reduced because less pressure and velocity are required while using drip (15 psi to 30 psi as opposed to up to 100 psi for overhead irrigation)
Drip Irrigation Benefits (continued)
Reduces chances for disease since water is applied to the ground and does not lay stagnant on top of crops
Systems are automated and sensor controlled Reduced watering time This results in lower carbon emissions (for diesel
pumping) and energy demand during peak summer hours
Drip Irrigation Cost and Savings
$700 to $1200 per acre installation cost Approximately $150 savings per year per acre This amount is rising due to all of the following:
Decreasing availability of water due to population sprawl Rising costs of a kilowatt hour and demand charges
Payback period is approximately six years however, increased product quality and yield per acre may decrease the payback period
For More Information Case studies of these other technologies
are available http://www.rowan.edu/cleanenergy Contact Rowan University Clean Energy:
[email protected] or (856) 256-5300