Optical Scope Stalker - Amazon Web Services · 1 Optical sight Stalker 1 PC. 2 Neoprene cover 1 PC....
Transcript of Optical Scope Stalker - Amazon Web Services · 1 Optical sight Stalker 1 PC. 2 Neoprene cover 1 PC....
Manual
Optical Scope Stalker
March 2018
PLEASE READ CAREFULLY THE RULES OF STORAGE, USE
AND THE INSTALLATION OF THE SENSOR BEFORE ITS OPERATION!Failure to follow the rules of operation, installation and storage of parts of the sight may be the cause of the loss of the
manufacturer's warranty.
WARNING! With long-term storage of the sight, in order to avoid cases of battery leakage and oxidation of electrical contacts, it is not
recommended to leave the battery in the case.
TABLE OF CONTENTS
1 APPOINTMENT 4 .............................................................................................................................................................................
2 SPECIFICATIONS 5 .........................................................................................................................................................................
3 SET OF DELIVERY 6 .......................................................................................................................................................................
4 Instructions and Nomenclature 7 .......................................................................................................................................................
4.1 Appearance and scope of the Scope 7 ............................................................................................................................................................................
4.2 Reticle 8 ........................................................................................................................................................................................................................
4.3. Operation procedure 9 ..................................................................................................................................................................................................
4.3.14.3. Operation «Picatinny». 9 ......................................................................................................................................................................................
5 Trouble Shooting 11 ...........................................................................................................................................................................
6 MAINTENANCE 12 .........................................................................................................................................................................
7 TRANSPORTATION AND STORAGE 12 .......................................................................................................................................
С. " 2
The sight and components should be stored at a temperature of at least 5 ° C and relative humidity of not more than 80% at a
temperature of plus 25 ° C away from heating appliances. The battery must not be stored inside the scope. 12 ................................
During storage, the sight should be protected from shock and direct sunlight, moisture and dust on the optical components.
Maintenance of the sight during storage is not carried out. 12 .............................................................................................................
The transportation of the sight in the case can be carried out by any mode of transport without restriction by distance, including by
air transport in a sealed compartment. 12.............................................................................................................................................
С. " 3
Настоящее руководство по эксплуатации предназначено для изучения устройства, работы и правил эксплуатации
оптического прицела «Stalker» (далее–прицел).
1 APPOINTMENT
The working temperature range of the sight is from -40 to +50 ° C.
Relative humidity up to 98% at 25 ° C.
The illumination of the grid of the sight is carried out from one battery of type AA with a voltage of 1.5 V.
The average operating time for the illumination of the sighting grid (in the maximum brightness mode) under normal climatic
conditions from the battery with a capacity of 2.4 Ah per hour is 200 hours.
С. " 4
2 SPECIFICATIONS
The main parameters and characteristics of the sight are given in Table 1. Table 1 - Basic parameters and dimensions
Parameter, units Parameter value Meters
Magnification 6±0,3
Angular field of view, deg 2,8±0,14
Diameter of exit pupil, mm, not less than 5,3
Removal of exit pupil, mm 90±5
Limits of convergence of beam beams after exit from the eyepiece, dptr not more minus 3 and not less than 2
The resolution in the center of the field of view, ang. sec., not more than: 10
Weight of sight with batteries, kg, not more than 0,42
Overall dimensions (without eyecup and protective covers), (L × W × H), mm, not more than 161×54×70
С. " 5
3 SET OF DELIVERY
** Under a separate agreement
DELIVERY KIT
1 Optical sight Stalker 1 PC.
2 Neoprene cover 1 PC.
3 Manual 1 PC.
4 Packing box
ADDITIONAL SET OF DELIVERY *
5 Cleaning Cloth 1 PC.
6 Allen key S5 1 PC.
7 Battery type AA 1 PC.
8 Warranty card 1 PC.
С. " 6
4 Instructions and Nomenclature
4.1 Appearance and scope of the Scope
The appearance of the sight is shown in the figure 1.
3 7 6 10 2 1
4 5
8
9 Figure 1 - The appearance of the Scope
1 – Lens
2 – Scope Body
3 – Oucular Lens
4 – 6 position soft button for illumination
5 – Battery Cap
6 – Parallax Adjustment
7 – Windage adjustment (milliradian)
8 – Scope Mount «Picatinny»
9 – Locking Nuts
10 – Parallax detent handle
С. " 7
The button for controlling grid mode (4) is used to turn the
backlight on and off, as well as to select the intensity of the
glow of the sighting grid.
The covers (6) and (7) close the alignment hand wheel
alignment handles vertically and horizontally.
4.2 Reticle
In the sight there is a sighting grid, which has 7 levels of
brightness.
The appearance of the aiming net is shown in Fig.. 2.
А
Figure 2 Appearance of the Reticle
The sub-tensions are 1 mrad (10 cm / 100 m distance).
С. " 8
4.3. Operation procedure
4.3.14.3. Operation «Picatinny».
The position of the sight relative to the arrow's eye should be comfortable. The shooter should not stretch or move away from the sight to get a comfortable image through it.
4.3.2 Insert the battery into the battery compartment
according to the diagram placed on the body of the sight and tighten the cover (5) to ensure electrical contact. If the polarity of the battery is disrupted, the illumination of the sight grid does not work (although it does not fail), but the battery itself is subjected to accelerated discharge.
4.3.3 Rotate the dioptric adjustment ring of the eyepiece
(3) until the grid is sharp. If necessary, turn on the illumination of the reticle with the
button (4). 4.3.4 Adjust the parallax with the knob (10). 4.3.5 Adjust the sight to normal combat. The sight is equipped with a reconciliation mechanism.
The alignment hand wheels are located under the covers (6) and (7) (see Figures 1-4) and are equipped with a snap mechanism.
The aim of the sight to normal combat is as follows:- fix the sight on the weapon;-install a shield with a target or select the aiming point at a distance (for example, 50 m);
- fasten the weapon on the aiming machine;
- Point your weapon at the mechanical sight (fly with a slot) to the aiming point (if possible). At this stage, you can use a cold spotlight laser (LHP, not included in the standard delivery), inserted into the barrel of the weapon and indicating the geometric continuation point of the barrel;
- remove the covers (6) and (7).
- Turn the turret alignments of the sighting grid, achieve the alignment of the central point of the sighting grid with the aiming point, exposed to the mechanical sight or LHP;
- remove the weapon from the sighting machine and take out the LHP;
- Perform 3-4 single shots, carefully and monotonously
aiming at the aiming point; - determine the accuracy of the battle and the position of the
STP (midpoint of hit). The accuracy of combat is recognized as normal if it is not worse than the accuracy of combat for the corresponding type of weapon without a sight;
С. " 9
- - Enter the required STP adjustment in accordance with Table 3;
Таблица 3
Положение СТП Необходимые действия
Below
Turn the turret (6) in the "UP"
direction indicated on the handle of
the alignment screw.
Higher
Turn the turret (6) in the direction
opposite to the "UP" direction
indicated on the handle of the
alignment screw.
Left
Turn the turret (7) in the direction
opposite to the "Left" direction
indicated on the handle of the
alignment screw.
Right
Turn the turret (7) in the "Left"
direction indicated on the screw
handle.
С. " 10
NOTES:
The click of the mechanism of the displacement of the sight along the vertical and horizon is:
- 1 cm per 100 m distance (0.1 mrad).
- perform a series of control shots and make sure that the aiming point coincides with the point of hit of the bullet (if necessary, perform the adjustment again);
The sight is ready for work.
4.3.7 At the end of the current operation, turn off the illumination of the reticle , close the covers (6) and (7) tightly. Put on the protective cover (included with the scope).
DO NOT FORGET TO TURN OFF THE illumination AFTER USE !!!
5 Trouble Shooting
Aimed grid is not lit
Make sure that the battery is correctly installed in the sight
and that it is in good working order. If the image and grid are not sharp
Rotate the eyepiece ring and the handle (10), in
accordance with Section 4.3.3 of Section 4 of this manual.
The effect of condensation on the sight
In cold weather, moisture can condense on the outer lenses
of the eyepieces. In this case, it is recommended to periodically
cover the optical surfaces with anti-fogging composition (not
included in the basic set of sight) or wipe the optics with a
tissue.
С. " 11
6 MAINTENANCE
As part of routine maintenance it is recommended to wipe the optical parts of the sight from dust, moisture, etc. napkin (not included in the main set of sight).
7 TRANSPORTATION AND STORAGE
The sight and components should be stored at a temperature of at least 5 ° C and relative humidity
of not more than 80% at a temperature of plus 25 °
C away from heating appliances. The battery must not be stored inside the scope.
During storage, the sight should be protected from
shock and direct sunlight, moisture and dust on the optical components. Maintenance of the sight during
storage is not carried out.
The transportation of the sight in the case can be carried out by any mode of transport without
restriction by distance, including by air transport in
a sealed compartment. С. " 12
GUIDE
OPERATION Stalker
АО «Дедал-НВ» Россия, 107076,
Москва, ул. Стромынка, 18 Телефон: +7(495) 617-0596, +7(495) 617-0597
Факс: +7(495) 961-2749
http://www.nightvision.ru E-Mail: [email protected]
С. " 13