nokia metro bts
-
Upload
vikas-mishra -
Category
Documents
-
view
299 -
download
1
description
Transcript of nokia metro bts
1 © NOKIA MetroSite EDGE RF perf ver 1.0.ppt Customer Confinential
Nokia MetroSite EDGE BTS
RF Performance with EDGE Capable TRX
Juha T. Tikka, Ari Rehnberg2.6.2004 / Ver 1.0
2 © NOKIA MetroSite EDGE RF perf ver 1.0.ppt Customer Confinential
Nokia MetroSite EDGE BTSRF Performance
• This slideset gives RF performance values for GSM800, GSM900, GSM1800 and GSM1900 Nokia MetroSite EDGE BTS. These values can be used for customer tenders and as network planning values.
• Given RF performance values only apply for EDGE capable TRXs:
• The next pages describes how BTS output power and receiver sensitivity values are defined.
Code Description Version
469690A CTGA TRX UNIT EDGE 900 (A)
All
469691A CTDA TRX UNIT EDGE 1800 All
469874A CTGH TRX UNIT EDGE 900 (H)
All
469875A CTGJ TRX UNIT EDGE 900 (J) All
468654A WTFA TRX UNIT EDGE 800 All
468231A WTPA TRX UNIT EDGE 1900 All
3 © NOKIA MetroSite EDGE RF perf ver 1.0.ppt Customer Confinential
Nokia MetroSite EDGE BTSRF Performance
BTS Output Power:
• Shown figures are nominal output power values, which are based on the average of production measurements at TRX output connector
• Output power values are with GMSK modulation. With 8-PSK modulation, values are 2 dB less for 800 and 1900, and 4 dB less for 900 and 1800 MHz.
• Intelligent Downlink Diversity (IDD) doubles the received signal power at terminal and multiple diversity combining adds downlink gain by average of 2dB. Shown output power values are after air combining without antenna gain.
4 © NOKIA MetroSite EDGE RF perf ver 1.0.ppt Customer Confinential
Nokia MetroSite EDGE BTSRF Performance
BTS Receiver Sensitivity
• Shown figures are nominal sensitivity values, which are based on the average of production measurements at the BTS antenna connector - middle point of tolerance in TRX
• BTS sensitivity values are given without any frequency hopping gain etc.• Receiving options:
• 2-way diversity = Rx signal is received with two antennas (one X-pol) and signals are constructively combined using Interference Rejection Combining (IRC) method
• Single branch = RX signal is received with one antenna
• NOTE: In MetroSite, 2-way diversity is available when having two or more TRX’s/sector, or by using the optional TRX diversity module (available Q1/05 for 900 and 1800)
5 © NOKIA MetroSite EDGE RF perf ver 1.0.ppt Customer Confinential
MetroSite RF Performance in GSM 900
BTS Output PowerGSM 900
Output PowerdBm W
TRX output 41.0 13
IDD 45 32
BTS Receiver SensitivityGSM 900
SensitivitydBm
2-way diversity -114.0
Single branch -111.0
6 © NOKIA MetroSite EDGE RF perf ver 1.0.ppt Customer Confinential
MetroSite RF Performance in GSM 1800
BTS Output PowerGSM 1800
Output PowerdBm W
TRX output 41.0 13
IDD 45 32
BTS Receiver SensitivityGSM 1800
SensitivitydBm
2-way diversity -115.0
Single branch -112.0
7 © NOKIA MetroSite EDGE RF perf ver 1.0.ppt Customer Confinential
MetroSite RF Performance in GSM 800
BTS Output PowerGSM 800
Output PowerdBm W
TRX output 37.0 5
IDD 41 13
BTS Receiver SensitivityGSM 800
SensitivitydBm
2-way diversity -114.0
Single branch -111.0
8 © NOKIA MetroSite EDGE RF perf ver 1.0.ppt Customer Confinential
MetroSite RF Performance in GSM 1900
BTS Output PowerGSM 800
Output PowerdBm W
TRX output 37.0 5
IDD 41 13
BTS Receiver SensitivityGSM 800
SensitivitydBm
2-way diversity -115.0
Single branch -112.0