NLINE Order 10€¦ · · 2017-07-31Order NLINE ™ ... Add 2 pints of Pencool® 3000 and install...
2
CATALOG NUMBER 10 www.midwestwheel.com Order NLINE ™ PENRAY COOLANT CHART FOR MAINTAINING 50% ANTIFREEZE +32 0% System Capacity (Gallons*) System Capacity (Gallons*) +25 10% +20 15% +15 20% +10 25% +5 30% -5 35% -12 40% -23 45% -34 50% -50 55% -65 60% -75 65% -84 70% -70 75% -55 80% -43 85% -30 90% -5 100% Drain Coolant and Add Concentrated Antifreeze (Quarts) Freeze Point (deg. F) vs. Percent Antifreeze Drain Coolant and Add Water (Quarts) If the reading on your refractometer does not appear on the chart, the solution is over concentrated. Drain your system and start over by adding a 50/50 mix of Fleetcharge ® or DDC Powercool ® and water to your engine’s system. * 1 Gallon = 4 Quarts Coolant fundamentally consists of three components: WATER- Water is an excellent heat transfer fluid, but it can freeze, and causes engine components to corrode. GLYCOL- Glycol is added to provide freeze and boil-over protection. It reduces the heat transfer capability of water. It is usually mixed 50/50 with water. SUPPLEMENTAL COOLANT ADDITIVES (SCA’s)- Fully Formulated coolants contain many of the same chemical additives, regardless of brand. Nitrites are added to coolant to protect iron and steel components from cavitation, pitting and rust corrosion. Nitrates provide solder and aluminum protection. Silicate is also added to protect aluminum surfaces. Tolytriazole (TT) and sometimes Mercaptobenzothiazole (MBT) are used to protect copper and brass metals. Phosphate or Borate are pH buffers used to control alkalinity. The WATER and GLYCOL in your coolant will remain in service indefinitely, barring any contamination. The SUPPLEMENTAL COOLANT ADDITIVES (SCA’s) will become depleted and must be replaced per manufacturers recommendation. For a tested and proven cooling maintenance procedure, use Penray’s FILL-FOR-LIFE ® program. Utilize NEED-RELEASE ® filters to protect your engine for 150,000 miles or use PENCOOL ® cooling system liquids and maintenance filters. Pencool ® 3000 P/N NA 300016 & NA 300064 Oil Purge P/N NA 200264 2001 Cleaner P/N NA 200164 Refractometer P/N NA CTX2 Fahrenheit Test Strips P/N NA TS200 Pencool ® w/ Stabil-Aid ® Cooling Filter P/N NA NF3000 Need-Release ® Filter P/N NA NF2088SM, NA NF2095SM, NA NF2096SM Coolant Filter Elements P/N NA NF3088SM & NA NF3999SM
Transcript of NLINE Order 10€¦ · · 2017-07-31Order NLINE ™ ... Add 2 pints of Pencool® 3000 and install...
CATA
LOG
NUM
BER
10
www.midwestwheel.com
Order NLINE™
www.midwestwheel.com
Order NLINE™
PENRAY COOLANT CHART FOR MAINTAINING 50% ANTIFREEZE+32
0%
System Capacity(Gallons*)
System Capacity(Gallons*)
+25
10%
+20
15%
+15
20%
+10
25%
+5
30%
-5
35%
-12
40%
-23
45%
-34
50%
-50
55%
-65
60%
-75
65%
-84
70%
-70
75%
-55
80%
-43
85%
-30
90%
-5
100%Drain Coolant and Add Concentrated Antifreeze (Quarts)
Freeze Point (deg. F) vs. Percent Antifreeze
Drain Coolant and Add Water (Quarts)
If the reading on your refractometer does not appear on the chart, the solution is over concentrated. Drain your system and start over by adding a 50/50 mix of Fleetcharge® or DDC Powercool® and water to your engine’s system.* 1 Gallon = 4 Quarts
Coolant fundamentally consists of three components:
WATER- Water is an excellent heat transfer fluid, but it can freeze, and causes engine components to corrode.
GLYCOL- Glycol is added to provide freeze and boil-over protection. It reduces the heat transfer capability of water. It is usually mixed 50/50 with water.
SUPPLEMENTAL COOLANT ADDITIVES (SCA’s)- Fully Formulated coolants contain many of the same chemical additives, regardless of brand. Nitrites are added to coolant to protect iron and steel components from cavitation, pitting and rust corrosion. Nitrates provide solder and aluminum protection. Silicate is also added to protect aluminum surfaces. Tolytriazole (TT) and sometimes Mercaptobenzothiazole (MBT) are used to protect copper and brass metals. Phosphate or Borate are pH buffers used to control alkalinity. The WATER and GLYCOL in your coolant will remain in service indefinitely, barring any contamination. The SUPPLEMENTAL COOLANT ADDITIVES (SCA’s) will become depleted and must be replaced per manufacturers recommendation. For a tested and proven cooling maintenance procedure, use Penray’s FILL-FOR-LIFE® program. Utilize NEED-RELEASE® filters to protect your engine for 150,000 miles or use PENCOOL® cooling system liquids and maintenance filters.
Pencool® 3000P/N NA 300016 & NA 300064
Oil PurgeP/N NA 200264
2001 CleanerP/N NA 200164
RefractometerP/N NA CTX2 Fahrenheit
Test StripsP/N NA TS200
Pencool® w/ Stabil-Aid®
Cooling FilterP/N NA NF3000
Need-Release® FilterP/N NA NF2088SM,
NA NF2095SM, NA NF2096SM
Coolant Filter Elements
P/N NA NF3088SM & NA NF3999SM
Pencool® Sticker
P/N 61002020
Pencool® StickerP/N NA 61002020
Is the coolant over 1 year old?
Drain and flush with the appropriate cleaner (Penray NA 200164, NA 200264,
or NA 201549) then refill with Fully Formulated Coolant. Service Complete!
YES YES
YES
NO
PASS
NO
NO
NO
YES
FAIL
Test freeze point with Penray NA TS200 test strip (end pad). Is the coolant between -10° F and -60° F?
Adjust freeze point utilizing Penray coolant adjustment chart on the
front of the document.
Test SCA level with Penray NA TS200 Test Strip (middle pad). Adjust per recommendations using Pencool® 3000. If equipped with a coolant filter, replace with the proper Penray coolant filter listed on
the front of this document. Service Complete!
MIDWESTWHEEL.COM
IOW
A
MIS
SO
UR
I
DES MOINES1436 E. Ovid Ave.
office 515.265.1491fax 515.265.4120
parts fax 800.314.4329parts 800.888.0248
CEDAR RAPIDS200 50th Ave. S.W.main 319.365.4453fax 319.365.6327
parts fax 877.706.6085parts 800.332.5435
DAVENPORT8502 Northwest Blvd.
main 563.322.2671fax 563.322.5940
parts 800.553.1886
SIOUX CITY1819 E. 4th St.
main 712.252.7969fax 712.252.6149
parts 800.943.3534
CLEAR LAKE840 Hwy. 18 W.
main 641.357.7101fax 641.357.8190
parts fax 800.548.9674parts 800.397.5630
KANSAS CITY5801 E. Front St.
main 816.471.1552fax 816.471.0813
parts 800.821.7402TRUCK PARTS
SUPER STORETM
August 2017 (10Penray Coolant Chart)
Drain and flush with the appropriate cleaner (Penray NA 200164, NA 200264,
or NA 201549) then refill with ELC - OR -
Want to convert to fully formulated? Add 2 pints of Pencool® 3000 and
install Penray coversion sticker (Part # NA 61002020.) Service complete!
AUTOMOTIVE FULLY FORMULATED COOLANTS
EXTENDED LIFE COOLANTS (ELC)
GREEN
BROWN
PURPLE FUCHSIA BLUE GOLD GREEN
YELLOW ORANGE AMBER RED
Test freeze point with refractometer. Is the reading at -12° F or colder?
Want to convert to fully formulated?
Add 2 pints of Pencool® 3000 and install Penray coversion sticker (Part #
NA 61002020.) Service complete!Is the coolant 300,000 miles or 3 years old?
Drain and flush with the appropriate cleaner (Penray NA 200164, NA 200264, or NA 201549) then refill with
ELC. Service Complete!
Add 1 quart of ELC extender per
manufacturer’s instructions. Service Complete!
Using Penray NA TS200 test strip, test coolant and compare to the ELC pad
(closest to fingers). Does it pass or fail? *NOTE: Penray NA TS200 will not test OAT
coolants for contamination.
Service complete!
