New TS Belt Grinder - Robert Bosch GmbH · 2020-06-17 · heat press for fusing the ends of the...
Transcript of New TS Belt Grinder - Robert Bosch GmbH · 2020-06-17 · heat press for fusing the ends of the...
We reserve the right to make technical changes at any time without notice. Page 1
IndustrialHydraulics
Electric Drivesand Controls
Linear Motion andAssembly Technologies
ServiceAutomation
MobileHydraulicsPneumatics
BRL SIS (Sales Information Service)Date:Issued by:
Bosch Rexroth Corporation • 816 East Third St., Buchanan, MI 49107 • 269-695-0151 10-26-2006
PB-M10-06 USProduct Bulletin - Flexible Assembly Conveyors
New TSplus Belt Grinder
As part of Bosch Rexroth’s commitment to product improvement, a newTSplus belt grinder is now available.
The new grinder offers many ergonomic improvements over the formerversion. They include:
1. New lightweight design - 10.5kg (an 18kg reduction in weight).
2. Extruded aluminum profile base with rubber feet and handle for easier handling.
3. On/Off switch located on top of the motor for quick access .
This new grinder is included in both welding kits (Size 1 & Size 2) and isalso available as a separate component.
Please replace page 3-9 in your TSplus catalog, version 3.5 with thefollowing page.
Belt Drive Components 3–9
To weld belt ends together, a Size1 or Size 2 belt welding kit isneeded. The Size 1 belt welding kitis used on conveyors 160 mm to480 mm wide; the Size 2 kit is usedon conveyors 560 mm to 1040 mmwide. Each belt welding kit in-cludes a belt-grinding device forbeveling the ends of the belt, aheat press for fusing the ends ofthe belt together, and a ratchet-tensioning unit and clamping jawfor pre-tensioning. An abrasiveband, brush, cleaning agent andadhesive are also included.
To cut welding time in half, asecond heating press is recom-mended for welding together twoadjacent belts at the same time.
NOTE: This kit is not intended foruse with toothed belts such asthose on BS2 transverse conveyors.
Belt Welding Equipment
Ordering Information for Belt Welding Equipment
Tensioning Device
Adhesive
Belt Grinder
Clamping Jaw
Belt Heating Press, 110VAC, 60Hz
Description Part Number
Belt Heating Press, 110VAC, 60Hz 3842 315 101
Size 1 - for 160 mm to 480 mm conveyors includes:grinder, heating press, tensioner, clamping jaw, and adhesive 8981 021 288
Size 2 - for 560 mm to 1040 mm conveyors includes:grinder, heating press, tensioner, clamping jaw, and adhesive 8981 021 289
Belt Grinder, 110VAC, 60Hz 8981 021 287
Belt Adhesive, 50g, (1.75 oz). 3842 315 106
R980 023 722
R980 023 721
R980 023 723
NEW