New Technique for Using the Jetropha and Karanja
Transcript of New Technique for Using the Jetropha and Karanja
-
8/4/2019 New Technique for Using the Jetropha and Karanja
1/33
By
M.KARTHIKEYAN
M.E. AUTOMOBILE ENGINEERINGMADRAS INSTITUTE OF TECHNOLGY
ANNA UNIVERSITY
NEW TECHNIQUE FOR USING THE JATROPHA
AND KARANJA OIL IN DIESEL ENGINE
-
8/4/2019 New Technique for Using the Jetropha and Karanja
2/33
INTRODUCTION
To solve both the energy concern and environmental
concern, the renewable energies with lower environmental
pollution impact should be necessary.
Biodiesel is renewable and environmental friendlyalternative diesel fuel for diesel engine.
Biodiesel has higher viscosity, density, pour point, flash
point and cetane number than diesel fuel.
Also the energy content or net calorific value of biodieselis about 12% less than that of diesel fuel on a mass basis.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
3/33
ENGINE SETUP
-
8/4/2019 New Technique for Using the Jetropha and Karanja
4/33
ENGINE SPECIFICATION Engine manufacturer :Kirloskar oil engines ltd
Bore& stroke :87.5 x 110 (mm)
Number of cylinders :1
Compression ratio :17.5: 1
Speed :1800 rpm
Cubic capacity :0.661 litres
Method of cooling :water cooled
Fuel timing :27 by spill (btdc)
Clearance volume :37.8 cc
Rated power :8 hp
Nozzle opening pressure :200 bars
-
8/4/2019 New Technique for Using the Jetropha and Karanja
5/33
TEST METHOD
The engine was operated initially on diesel for warm up and then withJatropha and karanja oil blends.
The experiment aims at determining appropriate proportions ofbiodiesel and diesel for which higher efficiency was obtainable.
Hence experiments were conducted for different proportions ofbiodiesel mixed with diesel.
The blends were in the ration 20%, 40%, 60%, 80% and 100% withdiesel. First these blends were tested at normal injection timing 27BTDC at constant injection pressure 200 bars and with a constantcompression ratio 17.5.
Then for the best efficiency blend, the tests were conducted at threedifferent injection timings 30 BTDC and 33BTDC and aboveprocedure was followed.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
6/33
RESULTS AND DISCUSSION
-
8/4/2019 New Technique for Using the Jetropha and Karanja
7/33
BRAKE THERMAL EFFICIENCY
-
8/4/2019 New Technique for Using the Jetropha and Karanja
8/33
BRAKE THERMAL EFFICIENCY
By advancing the injection timing, the combustion start
earlier than for standard injection timing.
Hence more amount of energy available from fuel is
utilized for engine power output. This is the reason for theimproved thermal efficiency of the engine.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
9/33
SPECIFIC ENERGY CONSUMPTION
-
8/4/2019 New Technique for Using the Jetropha and Karanja
10/33
SPECIFIC ENERGY CONSUMPTION
By varying the injection to 30 BTDC, B20 for both EEOJ
and EEOK blends having lesser specific energy
consumption due to availability of time in better fuel
mixing properties and spray characteristics.
Similarly further increase in injection timing leads to
decrease in the specific energy consumption of B40 blends
of EEOJ and EEOK.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
11/33
CARBON MONOXIDE EMISSIONS
-
8/4/2019 New Technique for Using the Jetropha and Karanja
12/33
CARBON MONOXIDE EMISSIONS
By advancing the injection timing to 30 BTDC, the HC emissions for
B100 of EEOJ, EEOK and its blends with diesel decreases from B100
to B20.
This is due to complete oxidation of carbon monoxide to carbon
dioxide will occurs. If the injection timing is further advanced to 33BTDC the B20 blend having more CO emission and others blends of
EEOJ and EEOK having lesser CO emissions when compared to
diesel.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
13/33
CARBON DIOXIDE EMISSIONS
-
8/4/2019 New Technique for Using the Jetropha and Karanja
14/33
CARBON DIOXIDE EMISSIONS
By varying the injection timing to 30 BTDC the carbon
dioxide emissions are increases from B100 to B20 for
both the oils of EEOJ and EEOK, with diesel at the least.
This is due to complete oxidation of carbon monoxide tocarbon dioxide taking place.
Further advancing the injection timing to 33 BTDC B40
nearly equal to diesel and CO2 emissions increases from
B100 to B20.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
15/33
CARBON DIOXIDE EMISSIONS
In general, bio diesel themselves are considered carbon
neutral because, all the CO2 released during combustion
has been sequestered from the atmosphere during the
process of photosynthesis for the growth of vegetable oil
crops, which are later processed into fuel.
Hence, bio diesel also helps to mitigate global warming,
as carbon dioxide levels are kept in balance.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
16/33
UNBURNED HYDRO CARBON EMISSIONS
-
8/4/2019 New Technique for Using the Jetropha and Karanja
17/33
UNBURNED HYDRO CARBON EMISSIONS
The HC emission for diesel at maximum load was 499ppm where as for B100 of EEOJ and EEOK were 543 ppmand 548 ppm respectively at an injection timing of 27BTDC.
However, HC emission was lower for blended fuels (B20& B40) as compared to B100 and diesel at full load. When
blend ratio increases from B20 to B40, HC emissiondecreases by 1.3%.
This is due to the fact that cetane number of ester basedfuels is higher than that of diesel.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
18/33
UNBURNED HYDRO CARBON EMISSIONS
The effect of shorter delay period resulting in lowers the
HC emission. In addition, the intrinsic oxygen contained
by the esters was responsible for the reduction in HC
emission.
It is clear from figures at B40 blend of EEOJ produces
lower HC emission compared to EEOK at full load
condition.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
19/33
SMOKE EMISSIONS
-
8/4/2019 New Technique for Using the Jetropha and Karanja
20/33
SMOKE EMISSIONS
It is clearly observed from the fig that the smoke
emissions are reduced with advance injection timing in
normal diesel engine.
At this same injection timing, smoke emissions for B20blends of EEOJ and EEOK at 30 BTDC are 27.34 HSU
and 34.11 HSU respectively.
When injection timing advanced to 33 BTDC the smoke
emissions of B40 blends decreases to 34 HSU and 38.99HSU for EEOJ and EEOK respectively.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
21/33
SMOKE EMISSIONS
It is clearly observed from the fig that the smoke
emissions are reduced with advance injection timing in
normal diesel engine.
At this same injection timing, smoke emissions for B20blends of EEOJ and EEOK at 30 BTDC are 27.34 HSU
and 34.11 HSU respectively.
When injection timing advanced to 33 BTDC the smoke
emissions of B40 blends decreases to 34 HSU and 38.99HSU for EEOJ and EEOK respectively.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
22/33
SMOKE EMISSIONS
The experimental results clearly prove that the smoke
emissions decrease with advancing the injection timing,
because of the higher combustion chamber temperature.
At the same time NOx produced from the engine andexhaust gas temperature are higher than that of the diesel.
The other possible reason is a diffusion combustion part
becomes less significant and thus smoke is lowered.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
23/33
OXIDES OF NITROGEN EMISSIONS
-
8/4/2019 New Technique for Using the Jetropha and Karanja
24/33
OXIDES OF NITROGEN EMISSIONS
It is clearly observed from the figure that advancing the
injection timing increases the NOx emission of B40
blends.
When injection timing is advanced to 30 BTDC, the NOxemission of B20 blends increases to 655 ppm and 655
ppm for EEOJ and EEOK respectively.
Further injection timing advanced to 33 BTDC, the NOx
emission of B40 blends increases to 731 ppm, 769 ppm forEEOJ and EEOK respectively.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
25/33
OXIDES OF NITROGEN EMISSIONS
It is clearly observed from the figure that advancing the
injection timing increases the NOx emission of B40
blends.
When injection timing is advanced to 30 BTDC, the NOxemission of B20 blends increases to 655 ppm and 655
ppm for EEOJ and EEOK respectively.
Further injection timing advanced to 33 BTDC, the NOx
emission of B40 blends increases to 731 ppm, 769 ppm forEEOJ and EEOK respectively.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
26/33
OXIDES OF NITROGEN EMISSIONS
The experimental results clearly proved that, when the
injection timing was advanced, an increase in the NOx
emissions for all the fuel mixture was observed.
This is due to combustion starts earlier, and thus theresidual time of the burning mixture in the cylinder and
combustion temperature is increased, thus allows the NOx
formation reaction to proceed.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
27/33
CONCLUSION
-
8/4/2019 New Technique for Using the Jetropha and Karanja
28/33
Almost same power output is noticed in all blends with
slightly reduced thermal efficiency, because of reduced
calorific values of the bio diesel fuels.
The engine performance with bio diesel up to blends wasnearly similar to that of diesel.
Slightly higher specific fuel consumption was observed at
full load for B40.
ENGINE PERFORMANCE AND EMISSIONS AT 27 BTDC
-
8/4/2019 New Technique for Using the Jetropha and Karanja
29/33
ENGINE PERFORMANCE AND EMISSIONS AT
30 & 33 BTDC
The 3 advance gave best result for bio diesel and 6BTDC crank angle degrees produced high exhaust gastemperature and higher levels of NOx formation.
When engine was operated at an advanced injection timingof 33 BTDC the engine knocked severely due to rapid
burning.
This severe knocking caused higher rate of pressure andtemperature raises that led to increase of NOx level due to
advancing the injection timing and subsequentimprovement of the combustion characteristics.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
30/33
ENGINE PERFORMANCE AND EMISSIONS AT
30 & 33 BTDC
Up to 40% of bio diesel blends with diesel can be used ina diesel engine without any modification in injectiontiming and without sacrificing the power output.
Bio diesel from Jatropha and Karanja oil is a promisingalternative fuel for diesel engines.
The entire test characteristics of bio diesel and its blendswith diesel demonstrate that almost all the important
properties of bio diesel and its blends are in very close
association with the diesel making it applicable incompression ignition engine for partial replacement ofdiesel fuel.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
31/33
REFERENCES
Agarwal D. and Agarwal A.K. (2007a) Performance and emissioncharacteristics of Jatropha oil (preheated and blends) in a directinjection compression ignition engine. International Journal ofApplied Thermal Engineering, Vol.27, pp. 2314-2323.
Narayana Reddy J. and Ramesh A. (2006) parametric studies forimproving the Performance of a Jatropha oil-fueled compression
ignition engine, International Journal of Renewable Energy, Vol. 31,pp. 1994-2016.
Murugasen A., Umarani C., Subramanaiam R. and Neduchezhian N.Bio diesel as an Alternative Fuel for Diesel Engine A Review,International Journal of Renewable and Sustainable Energy Review2007.
Paramanik K. (2003) Properties and use of jatropha curcas oil anddiesel fuel blends in a compression ignition engine, InternationalJournal of Renewable Energy. Vol. 28. Pp. 239-248.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
32/33
REFERENCES
Abdul Kalam A.P.J. (2007) Energy independence from plant earth,
Inaugural Address on 94th Indian Science Congress, Annamalai
University,. Chidambaram, p.3.
Senthil P. K., Jayaraj S. (2009) Performance and Emission Studies on
a 4 Stroke Diesel Engine using Methyl Ester of JME Oil with EGR,M.E., Thesis, Anna University, CHENNAI.
Murugesan A. (2009) Experimental and theoretical Investigation of
using Biodiesel in Diesel Engines; Ph.D., Thesis. Anna University,
CHENNAI.
Sundarapandian and Devaradjane, Performance and Emission
Analysis of Bio Diesel Operated CI Engine, Journal of Engineering,
Computing Architecture.
-
8/4/2019 New Technique for Using the Jetropha and Karanja
33/33
THANK YOU