National Hardware Show May2011
-
Upload
administaffstevelee -
Category
Documents
-
view
328 -
download
2
description
Transcript of National Hardware Show May2011
MAY 10-12, 2011
illumi-knob™ motion sensing doorknob light Glows when you need it
Open core for access to lock or keyhole
Dual high-brightness LEDs (various color options available); ten-second auto-dimming shutoff feature
Color-tinted, faceted polycarbonate lens
108-degree passive infrared sweep with 8-foot range
ABS construction (various color options available)
Fitted shape (standard doorknob becomes sleek handle)
Standard doorknob
3 AAA batteries (6- to 9-month lifespan)
Adaptable silicone boot
Manual on/off switch
Jump Starter™ Car-Battery Charger Safely charges a car battery using 12V vehicle cigarette lighters
Display screen
Top
Bottom
Hand-crank recoils the cable
10-foot cable extends between “low-battery” car and “full-battery” car
No need to lift the hood! Recharges a low battery in approximately 15 - 30 minutes.
Triangle Emergency Flashing Signals Attaches to a vehicle that’s alongside a road or highway during an emergency
Six super-bright LEDs (continuous illumination or flashing mode)
Magnetic base to place on the trunk or the hood
Flip-up design (measures 5" tall x 51/2" wide x 1.0" thick)
Strong, durable construction; splashproof
Round Emergency Flashing Signals Place on the ground alongside a road or highway during an emergency
Three super-bright LEDs (continuous illumination or flashing mode)
Splashproof; strong, durable construction—withstands impact if a vehicle drives over it
Measures 3.5" diameter x 1" thick
Push ’n Hang™ Push-Hammer Hangs pictures fast! No smashed fingers!
Non-marring TPE soft-touch foot
Nail-support magnet
Comfortable, ergonomic nonslip grip fits nicely in the palm
Built-in magnetic nail-storage compartment.
Magnet
TPE plunger boot
Drive-distance adjustment sleeve
General/Finishing Hammer with Integrated Nail Set Storage
Nail set stores flush—doesn’t interfere with grip
Magnetic nail starter Mini claw for tight spots
Includes 1/32 and 3/32 nail sets
Press to pop the nail set from the handle
1/32 nail set
3/32 nail set
SPRING 2012
ProScriber™ Arc Marking Tool Quickly and easily marks perfect curves of any size
Vertical/horizontal bubble levels
Belt clip
ABS construction
Adjustable-fit slider
Surface mount with 360˚ swivel
Multi-scriber support holds: • Carpenter’s pencil • Standard No. 2 pencil • Grease pencil • Utility knife blades • Tungsten Carbide scribing tool • Felt-tip pen
Scriber mount magnetic pocket
SPRING 2012
Combination Level and Square Multi-purpose interlocking tool
Snap-fit interlocking connectors
Works as multi-axis level
Works as multi-axis square
Multi-bubble level alignment (0˚; 45˚; 90˚)
SPRING 2012
Hi-Viz Level The hands-free, easy-to-read level instrument
Retractable bungee straps and fastening clips keep it securely mounted to an object, for convenient, hands-free use
Easy-to-read altimeter-style level indicatorExtruded aluminum frame
SPRING 2012
Hi-Viz Level Series Various styles of hands-free, easy-to-read level instruments
Aluminum: It can be configured for 12-, 24- and 36-inch designs
Extruded aluminum frame
Removable single magnetic level: It can be configured for 12-, 24- and 36-inch designs
Extra-large, single magnetic level
Trio level version: 0-, 45- and 90-degree indicators
SPRING 2012
Measure & Hang Combination tape measure and hammer all in one—perfect for indoor and outdoor projects!
Durable steel-forged surface for hammering
Molded palm-fit rubber grips
Carabiner clip
Tape measure
Thumb stop/lock
SPRING 2012
HammerBar Sliding hammer-assist helps get a pry bar into tight spots
Cast steel
Slide-hammer
Forged steel tempered blade
Slide the hammer forcefully in order to jam the pry bar into the tight spot
Hammer also serves as an ergo-grip
SPRING 2012
Cord Lock™ Helps prevent cord theft; also keeps power tools from “walking away”!
Center pivot
Cord Lock in open position
Opening for a padlock (prevents from pivoting open)
Dual openings for cord to pass through
Ideal for locking an exposed engine block heater to an extension cord. Use a padlock (not included) to keep the Cord Lock firmly closed.
Locks a cord around a post to help prevent theft—perfect for protecting construction equipment that must be left unattended.
Double-Grip™ Pliers Extra inside handle doubles grip & control
8" Slip Joint
Semi-flexible thumb support for better leverage and improved comfort
8" Long Nose
Precise, nonslip operation due to soft, contoured finger gel pads
Ergonomic inside grip with soft gel material for greater control and comfort
Design adaptable to:
Bent Long Nose Lineman’s
Diagonal Cutting
Multiple custom-color variations available
8" Linesman (not shown)
Available in open stock or custom sets
Double-Grip™ Precision Pliers Extra inside handle doubles grip & control
5" Bent Long Nose
Rubber hinged clasp for holding tool closed when not in use
Soft, contoured finger gel pads for secure, nonslip operation
#45 heat-treated carbon steel with micro-nickel or black-nickel finish
Ergonomic, wishbone-style inside grip with soft gel material for greater control and comfort51/4" Bent Long Nose
41/4" End Cutter
51/2" Flat Nose
4" Wire Cutter
Available in open stock or custom sets
Stretch-Grip™ Pliers Precise control like no other!
Drop-forged, heat-treated carbon steel with micro-nickel finish
Ergonomic inside gripThumb support
All-weather, nonslip urethane-foam grips
8" Slip Joint
8" Long Nose
Available in open stock or custom sets
Stretch-Grip™ Precision Pliers Precise control like no other!
Ergonomic, wishbone-style inside grip
All-weather, nonslip urethane-foam grips
4" Bent Nose
4" Long Nose
4" Flat Nose
4" Wire Cutter
Drop-forged, heat-treated carbon steel with micro-nickel finish
Available in open stock or custom sets
Select-a-Socket™ Multi-Wrench 10 sockets in 1 tough tool
Multiple socket heads—each size is a solid 6-point socket: 3/8" 5/16" 1/2" 7/16" 5/8" 9/16" 3/4" 11/16" 7/8" 13/16"
Socket-head selector
Socket-head adapter fits on either side
Includes ratchet.
Sure-grip TPE handle
Ratcheting Nut Driver Set Speeds up fastening or adds greater torque when driving a nut
Ratcheting socket
Tightening/loosening indicator arrow
Wrench-assist hex nut
Removable shank
SPRING 2012
Offset Drive Ratchet Easily removes fasteners from awkward, hard-to-reach spots
Right-angle extension-ratchet drive
Enables user to get at fasteners that are unable to be reached by conventional ratchets
Dual purpose: works as regular extended handle ratchet when not using the offset drive
Socket receiver
Ratchet receiver
Ratchet
SPRING 2012
Autosizing Adjustable Wrench Spring-loaded jaw tips quickly and securely fit around any fastener
Lever arm instantly cinches jaws tightly
Loop grip provides greater range of leverage; allows better hold—with minimal effort
Angled, spring-loaded jaw tips allow the user to quickly push the jaws over the fastener
Jaw removes any slack
Rachet-like effect for quickly removing or tightening hex-head fasteners
SPRING 2012
Compact Foldout Wrench Conveniently folds up for easy storage and portability
Sliding extension
Rubber handle grip
Fully extended
Set of 3:
6" 8" 10"
Folded
SPRING 2012
Bucket Wringer® Keeps hands away from dirty mop water and harsh chemicals
Insert the mop (not included) between the built-in rollers. . .
. . .then step on the foot pedal to wring out the mop.
2-gallon capacity
Pivoting handle grip
Foot pedal
Durable LDPE construction
Water Saver™ Measures use to conserve water
Connects between hose and spray-nozzle.
3/4" male connector
LCD displays gallons or liters to 1/10 (0.0 to 999.9)
Press and hold to reset cumulative total. Also used to switch between gallons and liters before each use.
Free-spinning 3/4" female connector
Twist-lock battery cover (CR2032 coin cell)
Water Saver™ Shower Usage Meter A gauge to gauge how much water you’re using, how long you’re taking
• Measures and displays in gallons or liters• Usage-limit alert• Time/timer• Temperature (˚F/˚C)
Soft rubberized bezel
Flexible multi-position gooseneck design
Soft-touch buttons (set; input)
Impeller sensor easily mounts to a standard 1/2-inch connector
Different LCD screens:
Time and flow volume
Flow and timer
Temperature and flow volume
1:1 image
1:2 image
AquaHub™ Watering & Conservation Device Waters six areas using one faucet
Tubing connectors
Easy-grip twist valves
Standard 3/4-inch quick-connect
8-inch anchor stake for hub
50 feet of 1/4-inch polyethylene tubing (cut to fit)
6-inch sprinkler nozzle
SPRING 2012
Ergo Clippers Innovative hedge clippers with new ergonomic handle design provides better comfort and improved trimming consistency
Pivot point
Cutting blades Telescoping handles
Nonslip, ergonomic rotating handle grips
Secure-lock for adjustable handles FALL 2011
Garden Ring Ensures that plants retain the amount of water given, while strengthening the root system to help minimize erosion
12" tall 12" diameter
3/8-inch-thick ring
Hydration control well
UV-resistant plastic
Erosion control wall
FALL 2011
The Original TreeEZwater® Self-Watering System Finally a way to water your tree standing up!
Hydrostatic EquilibriumAs the water level drops in the tree-stand reservoir, the TreeEZwater outlet is exposed. This allows air to travel up the tube and into the bottle. The water in the bottle is displaced and sent down into the tree-stand reservoir until the outlet is underwater again.
Tree branch hanger support
Easy two-part assembly
Total height: 36"
Standard 6-foot tree.
Seal-tight gasket
Spill-control spout
Maintains 2-inch water level
16-unit PDQ floor display
1.2-liter water bottle
The Original TreeEZwater® System Finally a way to water your tree standing up!
Tree branch hanger support
Easy two-part assembly
Total height: 32"
Standard 6-foot tree.
Maintains 2-inch water level
Earth Anchor Install and hold outdoor poles and posts into the ground—without using concrete or machinery!
Instructions:1. Turn the threaded ring clockwise until the
hinged arms are able to flip down so they’re perpendicular to the ground; insert the tip of the threaded anchor into the ground.
2. Hold the two hinged arms and screw the threaded anchor into the ground until it reaches the top of the thread. (Do not drive the anchor into the ground using a hammer or similar tool or object.)
3. Insert the desired pole or post (outdoor umbrella for example) into the top opening on the Earth Anchor.
4. Fold up the two hinged arms so they grip the pole or post.
5. Tighten the threaded ring counterclockwise to securely fasten the hinged arms to the pole or post.
6. Flip down the latch levers to securely grip and hold the object (umbrella) in position.
Threaded anchor screw
Threaded ring
Hinged arms
Hinged arms
Latch levers
Large
Small
1 2 3
4 5 6
Large Earth Anchor holding umbrella.
Small Earth Anchor holding net post.
Deluxe Self-Feed™ Soldering Gun One-handed heat and solder application
Stainless-steel heating element with Teflon®- molded supports for unclogged solder distrbution
Trigger-operated solder feed
Solder spool (2 oz.) included; also sold separately
Infrared auto-shutoff sensor in handgrip
Safety rest
Heat-resistant ABS housing
On/off dial with variable heat settings
Also available in a Standard version, without variable-heat selection and auto-shutoff feature.
Quick-Release Impact Wrench™ Socket Tool Safety and convenience—without compromise
Quick-release safety anvil Hog ring
Conventional hog-ring anvil Pneumatic coupler
Red Mirror Effect Black Nickel
Optional standard impact-grade socket
Spring-loaded socket-retention cam
Socket-release button