Multiview Drawings. 1.Identify the following line types A B C D.
-
Upload
robert-evans -
Category
Documents
-
view
217 -
download
0
Transcript of Multiview Drawings. 1.Identify the following line types A B C D.
Warm Ups
Multiview Drawings
1. Identify the following line types
Warm Up – 3/4/14
AB
C
D
Identify the following as oblique, orthographic multiview, or isometric
Warm Up – 3/5/14
From the given isometric, sketch a multiview (top, front, and side). Do not dimension
Warm Up – 3/6/14
From the given isometric, sketch a multiview (top, front, and side). Do not dimension
Warm Up – 3/7/14
From the given isometric, sketch a multiview (top, front, and side). Do not dimension
Warm Up – 3/10/14
From the given isometric, sketch the orthographic
Warm Up – 3/11/14
From the given orthographic, sketch the isometric
Lesson – 3/11/14
2 2
2
3
7
Identify the following as isometric, orthographic, or oblique
Warm up – 3/18/14
Identify the following as isometric, orthographic, or oblique
Warm up – 3/19/14
In a 3rd angle projection (the American way of showing a multiview), label what would go in each space
Warm up – 3/20/14
Sketch the front, side, and top for this isometric
Warm up – 3/21/14
1. What is the difference between related and adjacent views?
2. A multiview drawing is made up of ________________ projections
3. What is the degree measurement between the 3 axes of an isometric view?
Warm up – 3/24/14
1. Print Multiview1 in Inventor2. Make up any other missing assignments3. Multiview Review packet
Agenda – 3/24/14
1. What three views are most commonly used in multiviews?
2. Lines that are NOT parallel to the isometric axes are called ___-isometric
3. If you include the height on your front view, should you include it on your side view?
Warm up – 3/25/14
TODAY1. Inventor2. Make up any other missing assignments3. Multiview Review packetWednesday
Finish review packetGo over review pack
Thursday-FridayMultiview Test
Agenda – 3/25/14
1. When you have a circular hole visible in your front view, what kind of line should form a crosshairs inside the circle?
2. Dimetric, Trimetric, and Isometric are all different kinds of THIS type of view
3. An oblique view is a specific type of this kind of axonometric view
Warm up – 3/26/14
1. What does the word “isometric” mean?
2. Give an example of adjacent views
3. Give an example of related views
4. If the height of your front view is 4 inches, what is the height of your side view?
Warm up – 3/27/14
1. REVIEW THIS UNIT’S WARM UPS, THEN TURN THEM IN
2. TURN IN ACTIVITY LOG3. IF YOU HAVE FINISHED YOUR REVIEW
PACKET (THAT INCLUDES #18), TURN IT IN (IF IT’S NOT FINISHED, LEAVE IN YOUR HANGING FOLDER)
4. CLEAR YOUR DESK. YOU ONLY NEED A PENCIL (OR PEN, JUST DON’T MESS UP)
Warm up – 3/28/14