8/16/2019 Motor 60Z02152 - 08[1]CAT 3306 Liner Projection

http://slidepdf.com/reader/full/motor-60z02152-081cat-3306-liner-projection 1/2

Especificações 3306 VEHICULAR ENGINE FOR 966R WHEEL LOADER

Cylinder Liner Projection

SMCS - 1211-11 ; 1211-12

Make reference to CYLINDER LINER PROJECTION in Testing and Adjusting for the complete

procedure.

1. Install tooling as shown. Tighten bolts (1) evenly in four steps:

1st step ... 5 lb. ft.(7 N·m)

2nd step ... 15 lb. ft.(20 N·m)

3rd step ... 25 lb. ft.(35 N·m)

Fechar o SIS

Tela anterior

produtos: ENGINE - MACHINEModelo: 3306 ENGINE - MACHINE 58ZConfiguração: 966R WHEEL LOADER 58Z00001-UP (MACHINE) POWEREDBY 3306 ENGINE

Número de Mídia -SENR2408-00 Data de Publicação -01/09/1981 Data de Atualização -11/10/2001

Page 1 of 2966R WHEEL LOADER 58Z00001-UP (MACHINE) POWERED BY 3306 ENGINE(Z ...

29/1/2009https://sis.cat.com/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/siswe ...

8/16/2019 Motor 60Z02152 - 08[1]CAT 3306 Liner Projection

http://slidepdf.com/reader/full/motor-60z02152-081cat-3306-liner-projection 2/2

4th step ... 50 lb. ft.(70 N·m)

2. Measure cylinder liner projection with dial indicator (7) clamped in 1P2402 Gauge Body (6) as shown.Measure at four places around each cylinder liner near the clamped area.

Cylinder liner projection measurement for any cylinder liner must be ... .0020 to .0056 in.(0.051 to 0.142mm)

Maximum permissible difference between all four measurements ... .002 in.(0.05 mm)

Maximum permissible difference between average projection of any two cylinders next to each other ....002 in.(0.05 mm)

Maximum permissible difference between average projection of all cylinder liners under one cylinderhead ... .004 in.(0.10 mm)

NOTE: If liner projection is not correct, turn the liner to a new position within the bore. If projection cannot be corrected this way, move the liner to a different bore. If the projection can not be corrected this way,make reference to Special Instruction, Form No. FM055228 for complete instructions on the use of 8S3140Counterboring Tool Arrangement.

(1) Bolts [5/8" NC, 5.5 in. (140 mm) long].(2) Crossbar (from 8B7548 Push-Puller)(3) 4B4281 Washers(4) 1P2394 Adapter Plate(5) 3H465 Plates(6) 1P2402 Gauge Body(7) 1P2403 Dial Indicator

Direitos Autorais 1993 - 2009 Caterpillar Inc.Todos os Direitos Reservados.Rede Particular Para Licenciados SIS.

Thu Jan 29 16:18:07 UTC-0300 2009

Page 2 of 2966R WHEEL LOADER 58Z00001-UP (MACHINE) POWERED BY 3306 ENGINE(Z ...

29/1/2009https://sis.cat.com/sisweb/sisweb/techdoc/techdoc print page.jsp?returnurl=/sisweb/siswe ...