Mori Seiki MV-Series MY-M6 Programming Manual (PM-MVF180M-0E)
Mori Seiki Pullstud CAT and BT2 - Lyndex-Nikken Seiki... · (800) 543-6237 (847) 367-4815 Pull...
Transcript of Mori Seiki Pullstud CAT and BT2 - Lyndex-Nikken Seiki... · (800) 543-6237 (847) 367-4815 Pull...
(800) 543-6237 (847) 367-4815 www.lyndexnikken.com
Pull Studsfor Mori-Seiki/DMG New NVX Machines Series
CAT 40 BT 40
Class 3A UNC Thread
• Magnetic particle crack tested
• Tensile and shear requirements per ISO and JIS standard
• All locations that make contact with ground spindle mechanism components are ground
• Base of pullstud flange is ground to assure perpendicular alignment between pullstud and taper of toolholder
• Tight pitch diameter tolerance helps maintain accurate concentricity between threads and knob limiting the expansion or flaring of the small end of the taper
Class 4g6g metric thread
• Magnetic particle crack tested
• Tensile and shear requirements per JIS 6339
• All locations of the pullstud that make contact withground spindle mechanism components are ground
• Base of pullstud flange is ground to assure perpendicularalignment between pullstud and taper of toolholder
• Ground Pilot and tight pitch diameter tolerance helpmaintain accurate concentricity between threads andknob limiting the expansion or flaring of the small end ofthe taper
Dual O-ring design for maximum leakage protection
Lyndex-Nikken Part #: C40-1500-MORI Mori-Seiki Part#: N29105
Lyndex-Nikken Part #: B40-1500-MORIMori-Seiki Part#: N29104